Zenith zd300y0 dehumidifier has 01 on screen and red bucket full light blinking. It only turns on for a second

Hi sharilyn a20...
You will have to buy and install a new bucket for your humidifier..
You may get by with trying to seal the crack with a good grade of silicone sealant.
Please take time to rate me

Unit needs to be tilted slightly back to drain, put a thin spacer on front wheels only.

The manual for the Zenith 30-pint dehumidifier is available here: http://www.homedepot.com/webapp/wcs/stores/servlet/ProductDisplay?storeId=10051&productId=202051348&langId=-1&catalogId=10053&cm_sp=BazVoice-_-RLP-_-202051348-_-x . Click on the More Information tab. The direct link for the manual is http://www.homedepot.com/catalog/pdfimages/c7/c7bae79a-98a8-4c05-9e59-8f2bd71106f7.pdf .

I hope this helps.

Cindy Wells

Cut out the plastic in the bucket where the hose attaches to allow the water through.

Hi,
There are many reasons why a dehumidifier willnot work or collect water.
Here is a tip that I wrote to help people to figure out what is going wrongwith their dehumidifier

Dehumidifier is running but no water is in bucket

heatman101

Hi,

There are many reasons why a dehumidifier will not work or collect water.

Here is a tip that I wrote to help people to figure out what is going wrong with their dehumidifier

Dehumidifier is running but no water is in bucket

heatman101

I've had the same issue with mine. I am a 12 year refrigeration tech. I checked the float switch which would normally cause that indication light. However manually pushing the switch and then checking it with an electric meter that was not the case. I think that is instead, an error code set by the manufacturer to assist the service tech when or if this failure occurs during the warrenty period. I also checked the next possible failure in the sequence of opperation which would be the compressor overload relay. That is sometimes why, as some people have posted, that after when unplugging the unit, it operates for a short time then again fails. In my case that was the failure. If that would have not been it than I would have tried the compressor start relay. I purchased the overload relay from my local HVAC/plumbing supply for around 7$. The control can easily be replaced by any handy homeowner. Also, as a service tech, 7$ and two wire nuts is better than a 145+$ service call.

Hi,

There are many reasons why a dehumidifier will not work or collect water.

Here is a tip that I wrote to help people to figure out what is going wrong with their dehumidifier

Dehumidifier is running but no water is in bucket

heatman101

This seems to be a fairly frequent complaint on these GE dehumidifiers, and none of the solutions I've read here or anywhere else have fixed mine. My hose is clear, straight downhill, tight to the nipple with a good gasket, no plugs visible in the nipple, but has always filled the bucket rather than drained through the hose (and it's always bone dry). After two years of this and emptying the bucket, I'm about ready to disassemble it to see if I can fix it but with all of the other unresolved complaints I've seen GE should step up to the plate and post a solution.

Hi.

If the red light is solid, that means that the Roomba is near to full discharge. If the light is flashing red, then the Roomba is completely out of charge.

If the Roomba is fully charged, then there may be a fault.

Here full list of light codes:

Pulsing Amber - Charging
Green - Fully Charged
Amber - Partially Discharged
Red - Almost Fully Discharged
Flashing Red - Fully Discharged"

Here manual

See also
Roomba DISCOVERY MODELS' DIAGNOSTIC TESTS