Need a shaft seal for a breadman tr2200c bread pan

I think you're going to have to take out the seal and put a new retaining ring on the shaft to keep it from falling out the bottom. If you're lucky you'll be able to pull out the old seal without destroying it.
A 5/16" external retaining ring should do the trick. Hardware store or Lowes should have 'em. Depending on how difficult you find it to force the ring down into the well in the pan to put in the shaft's groove, you may need a retaining ring pliers. The cheap ones from Harbor Freight (around $3) work fine.

You should be able to purchase a replacement pan here:

http://www.directpartsandproducts.com/bread-makers-tr2200c-c-837_838_841.html

The synthetic seal around the shaft which DRIVES the paddle is fried.
I need a replacement to fit on the shaft OR if necessary 2 new shafts with NEW seals

Hi...The seal can not be replaced. You will need a new bread pan. Sorry, Hank

Hi, The leaking is from the sealed bearing that the paddle shaft rotates on. It wears out over time. It can not be repaired and you will need a new bread pan. Sorry Hank

Hi, Unfortunately the sealed bearing and shaft can not be replaced. Hank

Hi,
The sealed bearing can not be replaced. You will need a new bread pan. Hank

http://stores.ebay.com/Bread-Machine-Parts-Finder

I read in a review that the pan can warp if you read instructions because it said to fist run the machine in quick bread mode to clear factory coating. Review said to run in quick bread mode with lid open so it doesn't overheat, heat warps the pan, so it pops out . However manuel never mentions to leave lid open. I just got one and hope they are right. I just ran it new no ingredients quick bread lid open...

I found the part at
Parts & Accessories: 
Phone: 1-800-738-0245 (Monday–Friday, 8:30 a.m. to 8:00 p.m., ET) 
http://www.saltoninc.com/