When I press the start botton the OP botton continue to flash, and the machine wont start.

Check the wall plug and verity you have power to the washer,.

If the screens are clean and it takes several times of starting it for the machine to start washing the only option left is to replace the inlet valves.

have you tried programming the doses, maybe your continuous dose is not programmed. if you did, botton switch damaged need to replace whole touch board

just press the botton of each cycle want u want,like add rinse press rinse botton and it will add rinse,press spin botton it will add spin,but for washing,cant coz already set the time,default program for wash and cannot change

See if this link will get you started.

http://www.fixya.com/support/t5155274-maytag_neptune_model_fav6800awq


http://www.fixya.com/support/t5958665-od_error_message_when_try_start_wash


You troubleshoot "OP" and "OD" similar. You can place a magnet over the left gray lid bumper with the lid raised and see if that will clear the OP error code with the lid open.

If it does then the lid magnet may be out of position in the inner lid.

You can't pull the Service Manual from Servicematters any more they have placed a coin slot on the site.

TO RESET THE MACINE PRESS THE ORANGE BOTTON (C),PRESS THE BOTTON UNDER THE AUTO DENSITY LIGHT,RETURN TO THE FIRST ORANGE BOTTON THEN THE AUTO DENSITY BOTTON, YOU HAVE TO BE FAST WHEN PRESSING THE BOTTONS, ALL THE LIGHT ON THE DISPLAY WILL GO OFF THEN PRESS 14 AND PRESS THE GREEN PRINT BOTTON,THE MACHINE WILL RESET AND START TO WORK, BUT IF THE PROBLEM COUNTNUE CHANGE THE FUSER UNIT.

I have found that it is a blockage I manually drain the water through the botton of the machine then the cycle continues as a short term fix. I am not a professional though

try and locate botton called ACCESS.on the OP Panel should be pressed after you enter you access code
hope that help ...if not try the START BOTTON

A --- B Setting the digital time.
( )
C __ D
Select home city first (if equiped):
Press C until regular timekeeping mode is reached. Hold A until seconds flash. Press C to get to city code. Use B and D to move city east or west to your home city. Press A to set and exit.

Set time, Date, etc:
Hold A until second flash. Press C until item to adjust is flashing. Press B or D to adjust. Press C to go to next item. Press B or D to adjust. Press A when done adjusting all items to exit.

Adjust hands (if equiped):
Press C until H-Set is reached. Hold A until time flashes. Press D to advance minute hand. Press B while holding D to set faster and continuously. Press D to stop hands when correct analog time is reached. Press A to exit H-Set mode. Press C to go back to timekeeping mode.

In Timekeeping mode B is illumination and D is time/day/date display advance.

Good luck,
Techjoel

Here is how to reset the photoconductor kit counter:

1. Make sure the new kit is installed and the printer is turned ON.

2. Open the front panel.

3. Hold the Cancel button in until the front panel LEDs flash.

4. Close the front panel