Were can I find a remote for htr 5790? - Yamaha HTR-5790 Receiver

Try hooking up the Spkrs sometimes if there is no load the override will shut the unit down so things don't blow.

See the answer I provided the first time you posted this....

Hi,
On the back of the Receiver plenty of "RCA inputs" ..you can use any of it except
"Phone /turntable" input and than select it from control knob the relevant input..
Take care and pls remember to rate me..
Thanks

there is a post to this already about checking your voltage inside the unit on the back right hand side and how that is done. my guess is your system is set up with all your other devices hooked into one wall outlet and you overloaded it. Or maybe used a ext amplifier to increase your wattage. IF you try out holding down the ABCD method as described and press input? it may overide the factory setting when the unit experience any type of power malfunction.

with a push of a button on the remote, it will tell you what that means. it could be a speaker out of phase. check the manual. good luck

After you force it to turn on, what do you see on display? (PRT8**, DC**, etc.)

Make sure you have set blu ray player out put to bitstream,if you have set to pcm for hd master audio and dolby true you need to have a amp to decode this and hook up with a hdmi cable.If your amp has hdmi in and out but no high def audio you may still get multi channel audio.

Hope this helps.
CABLE GUY.

Hi,


Yes, you would need an iPod to RCA Cable that will connect to your iPod and to the RCA Auxilliary input of the Yamaha HTR-5790 7.1 Channels Receiver. Similar to a Cygnett Groove Transit - MP3 Phone to RCA Stereo Cable or an iPod to RCA Retractable Cable.


Good luck and kind regards.

Took my Yamaha HTR 5790 to a repair shop for an estimate to repair. Cost me $50 for estimate to be applied to repair. It needed two circuit boards replaced at a cost of $390.00.

 

SOLUTION... they kept my $50 and I bought a new AV Receiver that WAS NOT a Yamaha.

 

WOW this worked.. Hold down the ABCDE and the preset tuning right arrow and then hit power.. It puts it into a diagnostic mode, but it stays on.. I just rerouted my video to not use the receiver  and the audio works perfectly now.