Northstar 952 and furuno 1715

You can interface the GP30 to the 1715 and get Lat/Lon readings where the cursor is. The GPS has extra wires in the power cable. The 1715 will require a NMEA cable pn 000-154-028. Connect the white GPS wire to the yellow radar wire and the blue GPS wire to the green radar wire.

The owner's manual for the 1715 is available at the link below.


http://furunousa.com/ProductDocuments/1715%20Operator%27s%20Manual%20C3%20%203-3-11.pdf

The operator's manual is available here: http://www.furunousa.com/Products/ManualList.aspx?category=Products+%3a+Radars+%3a+Radars . The direct link for the 1715 manual is: http://www.furunousa.com/ProductDocuments/1715%20Operator%27s%20Manual%20C2%20%209-27-06.pdf .

I hope this helps.

Cindy Wells

Here you go Sir,


http://www.fujiyachts.net/manuals/Furuno%201715%20Radar%20Operator's%20Manual.pdf

If you have no radar targets, go to longest range 24 miles, gain full, rain and sea minimum, do you have noise, if so, need magnetron, if not, need cable from display to dome.

Yes and it is in the book a new installation needs calibration!! The rough tuning is off by the sounds of it

internal damage to the display, fixable by Furuno, and probably economically feasible (guess $250 with round trip to Furuno)

If you call 410-228-7335 and ask for the service dept, they can call Furuno and obtain the motor for you.

i have a furuno 1700 radar ,when i switch it on it goes to stand by ,when i press the standby button you can see it scanning but no land appears cheers alan

Hello.

According to the operating manuals of the two radars (found on Furuno's Website (www.furunousa.com), they do use the same antenna cable.

Hope this was helpful.