My phone window just says 'Scanning....' It is fully charged. I cannot call forward from my main phone to the portable.

Start - Programs - Canon Utilities - U-Scan Utility

1. Make sure that the machine is turned on.
2. Flick the HOME screen, then tap Scan. ...
3. Tap Attach to E-mail.
4. Tap the computer to forward the scanned data. ...
5. Specify the settings as necessary. ...
6. Load the original on the platen glass.
7. Touch the Color button for color scanning, or the Black button for black & white scanning.

Canon : PIXMA Manuals : MG7100 series : Attaching the ...

ij.manual.canon > Manual > ug_scanning0800

Canon : Manuals : MG7120 : Scanning Easily Using IJ Scan ...

ij.manual.canon > WebPortal > PTL > ptl-service > mdl...

MG7120Scanning Easily Using IJ Scan Utility - Windows - IJ Scan Utility is an application for scanning photos, documents, and other items easily. Complete from scanning to saving at one time by simply clicking the corresponding icon in the IJ Scan Utility main screen.

hi. make sure that the handheld is correctly connected into the main body.

Need new battery

No not at all. It's pretty straight forward. It will jump start any car has good cranking amps. Make sure you fully charge it a good 24 hours before your first use. Than once a month recharge again to make sure the battery does not go flat. Good portable unit I love mine

Sadly, Bob is incorrect here. In a coaxial helicopter, the main rotors spin in opposite directions, equalizing the centrifugal force and allowing the craft to hover without spinning, fine-tuned by the adjustment of the trim control. The counter-rotating main blades and internal gyroscopes provide a stable hover, while the tail rotor serves only to push the rear of the chopper up or down, providing the forward/backward thrust. If you are not moving the right joystick, you tail rotor should be stationary, or perhaps moving lazily from the wash of the main rotors. Sounds like a charging issue. What type of charger are you using? Also, Li/Po batteries are not meant to be fully discharged. Fully draining a Li/Po too many times, ESPECIALLY when they are new, will ruin them. Luckily the batteries on an 032 are easily replaceable. Available on Amazon and many other online retailers, and replaced in about 1 minute with only a small screwdriver. With a new Li/Po, charge them FULLY with the correct charger, and always stop the flight as soon as you are having to give it full power to maintain altitude. Also CRUCIAL is you MUST MUST MUST let the battery rest and cool for after a flight, wait a good 10 minutes BEFORE you connect the heli to the charger, and another 10 minute cool down after charging before you fly.
Hope this helps
r

because of the wires

hi sir... dont change ur batteries or go for new one... Its becuase the battery pin available in ur mobile device has got damaged... so its unable to store charges for a longer duration...Better give ur mobile for service and they will replace u with new pins.. dont waste in getting new batteries..

thank u rate me!!!

There is a tiny little rectangle in the upper right corner of the main screen on the handheld. It's divided into 4 sections and each section lights up separately as the amount of charge goes down the light moves to the right. Fully charged all four sections are lit.

USer manual requires,
full charge 16 hours for expandable handsets, then place in cradle ~20 seconds until 'ready' is displayed on the screen.
If power is lost the handset may have to be re-registered.

if the units are not fully charged when you register them the registration may be lost, can only suggest reversing the order, by fully charging the device then registering to see if the registration holds