My canon PIXMA iP 4000 does'nt write out the colours, only black.

how to overcome my ip 2700 canon 006 error?

no both are different
Here are the list of cartridges u can use
MP210
PG-30 Pigment Black
PG-30 Pigment Black Ink Cartridge
PG-40 BLACK
CL-31 Color FINE Ink Cartridge
CL-41 Color
MP240
PG-210 Black Cartridge
CL-211XL Color Cartridge
CL-211 Color Cartridge
PG-210 XL Black Cartridge

Sounds like you need a new printhead.
QY6-0054-000. around $40.00

no if ur filling the catridge more times the printer going to damage

Canno ip 4000:

please go to the maintenance tab.
This you will find if you try to print anything.
In the print box >go to properties>go to maintence
Here the following Maintenance option are there:
cleaning,
deep cleaning,
Head Alignment,
Nozzle check.
Before your start maintenance, please check whether all print tanks have ink in them
Do a Nozzle check first, this will indicate where you have the problem. Once identified, you can do a color cleanig or a deep cleaning.
Do a Nozzle check again.
You could repeat this cycle about three times or so.

If your problem still persists, then its probably the Print head with jammed nozzles.

Please let me know whether you could solve it.
Please do rate this solution and thanks for using FixYa.

The printhead is clogged.

See the following guide:

Canon iP3000/4000/5000 Printhead Cleaning Guide

If it does not work, replace the printhead: Genuine Canon Print Heads

i need install info on a canon pixma ip 1600

I have the same problem with my ip 5200, when printing a document in plain black.. I spoke to canon support and they suggested to save the .doc document as a txt file before printing. It works. Not too sure if this uses any colour ink to produce the black.

You can also set the printer on grayscale. However, the printer uses the colour ink to produce black.... hence printing in black & white becomes rather expensive.

If anyone has drivers to fix this problem please let me know...

This is the REAL working method of manually resetting Canon ip1880 - ip 1980.

1. Unplug the POWER cord.
2. Press & hold the power button.
3. Connect the power cord WHILE holding the power button.
4. Keep on holding the power button for about 30 seconds.
5. Release the power button. The printer should be turned off.
6. Turn the printer on and that's it!

NOTE: You have to do this every time you turn on your printer. Or you will get the waste pad full error.

Hope this helps.
vulmec.wordpress.com

did zou refilled the cartridges?
Have you try another paper?