How to put in correct tome into the timer - Hotpoint UY46 Style Line Stainless Steel Electric Double Oven

that is not a problem. I copied the instructions straight from the manual which you can also review by clicking here.
Using the clock and timer.
To Set the Clock The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle. Press the CLOCK pad. Press the HOUR and MIN + or – pads to set the time of day. Press the START pad. Make sure the clock is set to the correct time of day. To Set the Timer Press the KITCHEN TIMER ON/OFF pad. Press the HOUR and MIN + or – pads until the amount of time you want shows in the display. The maximum time you can enter in minutes is 59. Cooking times more than 59 minutes should be changed to hours and minutes. For example, enter 90 minutes as 1 hour, 30 minutes. If you make a mistake, press KITCHEN TIMER ON/OFF and begin again. Press the START pad. After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down. When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed. The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle. The timer is a minute timer only. The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes. To Reset the Timer If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad, then press the HOUR and MIN + or – pads until the time you want appears in the display. If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the HOUR and MIN + or – pads to enter the new time you want. To Cancel the Timer Press KITCHEN TIMER ON/OFF pad twice.

If you need further assistance follow up with a comment and please let me know and i will be glad to assist you further. Thanks, Midwest-tek

I have one of these too. the TOP small clock should be set to the time you want the oven to start and the BOTTOM small clock should be set to the time you want it to turn off. Be sure to set the oven settings to what you want and the correct temperature.

Try testing it first just to see if it works correctly. It's also important to make sure the other large clock on the oven is set correctly.

no, but can i ask your general opinion of this as thinking of buying one

This code is usually oven sensor but alot of tomes I have found bad solder joint where the sensor harness plugs onto the main board. This can be resoldered to save costly exchange of the board. The oven sensor should ohm at 1000 ohms with a meter with a 10k setting.

You have reset the timer from the auto function, to the manual function.
You should see a hand symbol showing for manual operation.
It is a question of pressing the buttons in the correct sequence., or if it is a anologue timer, turning the knob until you see the hand symbol showing.
Hope this helps.

I've sorted it!!!

Though the timer module looked as if it was working the embedded relay was faulty. Note: This timer module is common with Hotpoit, Ariston and a handful of other manufacturers. They all require the relay to 'work correctly' as it switches the Neutral line which controlls all the functions of the Oven. As the delayed timer function was not requierd I moved the 'Switched' Neutral to a permenant connection on the 'Selector Switch' and Hey Presto its sorted. The hunt for a wiring diagram also proved impossible, though having traced the internal wiring carefully it appears that the overall wiring of the Oven, and I suspect others, is very simple to understand. Good luck to anyone else.

If your model # is ECOH-AP208DR, Electric Half Size Computerized Convection oven, the timer is as follows: 2J-30800-05 Timer Elec. 1hr 24V. Please check the time range of 1 hour and voltage on old timer be insure this is correct.

Check that the oven is not stuck in AUTO or TIMED mode. Also set the clock to the correct time if you can.

i got the same problem....................no solution so far

replace the control cpu unit the main control board is deffective