How do i push play on the jvc and does it have to be on a certain station.I just got car and it was in it but have no idea how to work it

You can only preset stations one by one. First, you can do a full scan for all stations in range. Press and hold the Stop button on the unit. Press Play/Pause to start the scan. (There are alternate methods using the remote control. See page 17 of the manual.) Press Fast Forward or Fast Reverse on the unit to navigate through the stations that have signal.

To set a preset, tune in a station using the Tune+/Tune- buttons on the remote or Fast Forward/Fast Reverse. Then press and hold Prog/Preset on the remote. When you see ##Empty or a preset number, use Tune+/Tune- to select one of the 20 preset storage numbers. Press OK/Play/Pause to save the preset. (If using the buttons on the unit, press Fast Forward/Fast Reverse to select a preset location. Press Play/Pause to save. You will see Stored on the display in either case, if you successfully saved the frequency to the location.

ManualsLib has the manual for the JVC UX-S327B here: https://www.manualslib.com/manual/1939546/Jvc-Ux-D327b.html#product-UX-D327B . See page 18 for presetting stations.

I hope this helps.

Cindy Wells

i have a funny feeling its the aerial but it could also be a faulty chip within the set itself i have had customers complaining of this before with certain makes of radio ,never get it with a grundig or bleupoint though

VC stereo systems come in a number of different styles and models, from portable "boom boxes" to stereo receivers designed to be used with entire entertainment systems. When a JVC stereo malfunctions, it's a good idea to perform a few basic troubleshooting steps to correct the problem. Often, the solution is very simple, involving something you can correct immediately and which will allow you to continue using your JVC stereo system without having to call a repairman.

generally wiring from the car is as follows...

red = ignition controlled live
yellow = permanent live

if you want stations saved and manual switch off of uni connect radio's yelow and red wires to the cars yellow.

if you want stations saved and radiounit switch off controlled by ignition (i.e only when car is running) then yellow to yellow and red to red. anything else will cause issues...

the battery probley shorted out your deck i think its time for a new one

You must be using an FM modulator then - the easy way is to put a cd in and press play then do a tuning search on FM and it will find it. Then save that station

I solved it thanks. Push the reset button behind the faceplae with a pin or toothpick, hold for few seconds and it resets.

I figured it out!! YAY!!!!
so here is how you set the presets:

- click source until you are on the FM radio
- click down or the play/pause button... this shows the presets
- pick which present you want to set your station on by going right or left
- press and hold down or play/pause button until preset number starts flashing
- once flashing, use right and left arrows to select your station (if you wait too long it will stop flashing and you will have to start again)
- once you have gotten to your station, push down or the play/pause button one more time, and it should be set!!

hope this helps, good luck!!

christy*

Have you checked the cables? It appears that you have connected the wire for ignition directly to the power in and the direct +12v to the ignition cable. When turning ignition off, the memory is then emptied.

you prolly need a new voltage regulator