I have a VPL-CX70 that has a new lamp (less than 50 hours) and the hours were reset to 0 when the new one was installed. However, today, the lamp cover LED started blinking and the projector shut itself down. Why is this happening? Thanks!

1,Connect the power cord
2,The On/Standy light is red.
3,Press the following keys on the Remote Commander or on the projector in the following order for less than 5 seconds :Reset,left,right,enter.

Have a nice day!
We supply original projector parts: lamp, bulb, Lcd panel, Lens, DMD chip, color wheel,
motherboard, powersupply ... with high quality and competitive price.
Jerry
Lampdeng Limited
Mobile: 0086-13178867858
Wechat ID: 008613178867858
Whatapp ID: 008613178867858
Skype: [email protected]
http://www.lampdeng.com

Hi,
DO the following for resetting the lamp hour
1.Connect the power cord.
2.Press the following keys on the Remote Commander in the following order for less than five seconds each: RESET, Left Arrow button, Right Arrow button , ENTER.
ok

1.unplug power cord
2.plug back in and it should be in stand by mode.(red light on)
3.do not power on
4.on remote push RESET,LEFT ARROW,RIGHT ARROW AND ENTER(do it in less than 5 seconds)
5.after you have done this power on and go to menu and it should show lamp hours 0
6.if it didn't work just do it again, it took me a couple of tries.

hi,
for resetting lamp hour do the following
press the following keys on the remote in the following order for less than 5 seconds each.

RESET then LEFT ARROW then RIGHT ARROW then ENTER
OK,

you must reset the lamp hour meter

These instructions are for a Sony Cineza VPL HS3, but may be the same for the HS2
1st thing to check - is the cover properly/completely closed - this can stop the projector from working.
Connect the power and set the projector to standby mode.
Press these buttons on the remote control in this order, for less than 5 seconds each.
Reset - Left Arrow - Right Arrow - Enter

This is required, to reset the lamp timer.

Also, something I found interesting from the internet - lamp life isn't when the bulb dies, but when a bulb has lost 10% of its brightness - so you might well be able to reset the timer and get much more use from the bulb - the image just wont be as bright.

HI
Not sure if its in the handbook but you can download a copy from here

http://safemanuals.com/user-guide-instructions-owner-manual/SONY/VPL-CS5-_E

Hello,

• Set the projector in standby mode.

• Press the following buttons on remote control in following order for less then five seconds each...

• RESET,

• <=== ,

• ===>,

• ENTER

Lamp timer is reset now.

This is also mentioned in user manual page 50
Thank you.

Used

To reset the lamp timer:
1) With the projector plugged in and turned off, press the 'ON/STANDBY' button to put the projector in 'STANDBY' mode. NOTE: You have to press the button on the projector itself, you cannot use the remote for this step (this is not clear in manual).
2) Now, using the remote, press the following keys in order: RESET, <--, -->, ENTER.
3) Timer should now read '0'.