My screen on my interainment system is flashing protector

Of course you can do it with a screen protector.
The Guide Of Reset Fitbit Charge HR Complete Guide

The computer is not producing a video signal.
The varistors in the surge protector are probably burned out, or there is some other problem in the surge protector.
The monitor is very likely OK.

if your pushing the power protector to on back its a resettable fuse an you have another insue inside shorting it out

What make and model tablet?
Unless your tablet has an unusual sized screen, you should be able to find a screen protector at just about any department, electronics, or office-supply store.

The amp is shorted and needs to be repaired

The "PROTECT" and "PUSH POWER" messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. Press the POWER button on the unit to turn off the system, and check the following items after "STANDBY" disappears.

1) Are the + and - speaker cords short-circuited?
2) Are you using only the specified speakers?.
3) Is anything blocking the ventilation holes of the system?

You may also refer to the following link for additional troubleshooting steps.

PROTECT and PUSH POWER flash alternately on the amplifier screen

Boot the laptop to safe mode and perform system restore to the earlier point. I am sure this will resolve your issue. I suggest you to do not download and install 2 anti virus software in one computer that will messup the computer as well. Thank you

tec rahul

dead short. Check wiring inside case. Power Protect keeps it for catching fire or electrical shock. Tech Fix only in most cases.

A wireless system such as the line of Pocket Wizards is a good choice- the are builr to professional standards and are very reliable.

If you wish to hard wire your flash unit to your digital camera, you can purchase a protector wivh reduces the trigger voltage to a safe level refatdless of the age or design of the flasg system you are goinf to use, Under no circumstances should you use this combunation of equipment without a radio triggering device or the protector, The protector attache to the hot shoe of the camera and provides a standard PC synch cord terminal for connecting your flash system to the camera.

You can test the voltage by putting a volt meter set a 250 or 500 VDC across the synch socket in the flasg unit, If the meter deflects negatively just revers the polaity for a correct reading. If there is under 5 volts there is ptobably no issue, however, I still would take no chasces abd use a radio or a protector. If the falsh won't fire with the radio or protector in place, tha probably means tha the synch voltage is very low.