Question about Whirlpool 24 in. DU1100XTP Built-in Dishwasher

1 Answer

Whirlpool Dishwasher DU1100XTPB7: The dishwasher starting making a really loud noise as it was going through it's cycles and it did that for about 2 weeks. Now the water will not run through the washer blades. We turn on the dishwasher and water just gathers in the bottom of the washer.

Posted by cnelson3340 on

Ad

1 Answer

Lawrence Oravetz

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Whirlpool Master
  • 10,548 Answers

The pump is most likely bad. If the dishwasher has some years on it, repairing might not be economical. Get some estimates, that will help with the decision to repair or replace.

Posted on Feb 14, 2018

Ad

5 Related Answers

bigg t

anthony james

  • 640 Answers

SOURCE: Dishwasher Making Loud High Pitched Noise.

How deep do you want to get into this?It sounds like the wash pump motor bearings that are worn.You can pull the unit out flip it over and wd40 the bearings in the motor or you can replace the bearings.Try to lube them first.

Posted on Feb 24, 2008

Ad

Ian Greenland

  • 351 Answers

SOURCE: Whirlpool dishwasher not draining

blockage in the drain hose somewhere

Posted on Mar 20, 2008

Anonymous

SOURCE: Dishwasher Making Loud High Pitched Noise.

Problem is with the main pump motor bearing. Water leaking from the face seal enters the front bearing. After some time, the bearing wears out bringing on the loud noise. The motor is easy to remove but the bearing requires some time to remove. I did not have access to a press so I ground off the bearing an replaced it with a shielded 8mmx22mm type. Grainger p/n 1L001. The part is only $9 compared to over $200 for a replacement motor. It takes some time and disassembly of the dishwasher can be difficult but take your time and be ginger with the parts. The root of the problem seems to be the impeller. It screws onto the motor shaft and seems to work loose after time. Since its tightness compresses the face seal, when it loosens water can seep. No way to lock it in place after tightening. Weak design point.

Posted on Sep 24, 2008

Anonymous

  • 1 Answer

SOURCE: whirlpool dishwasher reset code

Yup, found it on another site..I had the same issue today.

Reset code: Push 1. Heat Dry 2. Normal 3. Heat Dry 4. Normal

wait about 2 minutes as the controller resets itself. You should see all the leds flash on and then wash and rinse leds stay on for about 30 seconds. A minute or so later ..presto, my machine worked again.

My machine is not the GU3200XTP, but in the same Whirlpool tall tub series (same manual) so leds may not have the same name.

Mark

Posted on Oct 21, 2008

Anonymous

  • 11 Answers

SOURCE: Dishwasher Making Loud High Pitched Noise.

A loud high pitch whine while running the dishwasher means that there is something caught in the chopper assembly. To get to the chopper assembly you need to take the racks out and take the pump apart from the inside of the dishwasher. The chopper assembly looks like a metal grate with holes in it. And it might not even be stuck in the grate but somewhere in the pump area due to the water being pumped out, so the best idea is to take the whole thing apart and clean everywhere. However I do not recommend doing this unless you are completely certain you will remember where the screws and gaskets go, otherwise you risk damaging your pump or house from a leak or improper installation. You have been warned.

Posted on Jan 15, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a top load fridgidaire washer model fwsc445rfs0. During the wash cycle it makes a high pitched scraping noise.... Struggles also while it winds down before rinse. Bearing maybe?


How To Fix A Washing Machine Making Noise During The ...

removeandreplace.com/.../washing-machine-making-noise-during-the-sp...
Jul 27, 2015 - Agitator directional cogs aka "agitator dogs" (top load washers) ... If you hear a rubbing sound or the drum spins uneven, then the ... A washer making a loud noise during spin cycle can also be caused ... The clutch in a washing machine connects the inner wash tub to the ..... May 8, 2015; High Water Bill?

Dishwasher Making Loud Grinding Noise During Wash Cycle

removeandreplace.com/.../dishwasher-making-loud-grinding-noise-durin...
Apr 11, 2014 - Dishwasher Making Loud Grinding Noise During Wash Cycle ... GE, Whirlpool, Frigidaire, KitchenAid, Maytag, Kenmore, and LG) this is a .... Our Amana dishwasher is making a loud, high-pitched squealing noise throughout the wash ....Out Of A Washing Machine - Top Load & Front Load September 30, ...

All comments on Loud dishwasher Frigidaire Gallery mode ...

https://www.youtube.com/all_comments?v=v-arYb20kOk


Dec 03, 2015 | Washing Machines

1 Answer

Why is my whirlpool dishwasher making a loud noise during drain, wash and rinse cycles?


They can be complicated to re-assemble. Best solution is to video the procedure (if you have a video camera) during disassembly and make notes and diagrams to orient things properly and make sure the correct screws go back where they shoud. Takes more time, but you'll be glad you did, it will save you a lot of aggrevation in the long run.

Aug 24, 2014 | Whirlpool 24 in. GU1500XTLS Stainless...

1 Answer

Noisy Dishwasher


it is a capacitor to start the motor for the next cycle. I think it is inside the door. you may have to call a tech.

May 19, 2013 | Whirlpool GU2300XTVQ Builtin Dishwasher

1 Answer

Dishwasher makes noise during drain cycle


This really isn't a solution, but I found info on Whirlpool's site that the noise could be caused by the disposer and food or something in it. They said to use it a few cycles and see if the noise goes away, so that's what I'm doing. I always rinse dishes before going into the dishwasher, so don't really think there could be food particles etc. causing the problem, but we'll see. Not anxious to pay for a possible solution unless through a repair person. Thanks for your reply.

Jun 19, 2009 | Whirlpool GU3600XTSY Stainless Steel...

1 Answer

Whirlpool Dishwasher Model: GU2500XTPQ3 making loud whining noise


It's most likely coming from the wash motor bearings. Based upon the age of the dishwasher it might be time for a new one. Although it can be fixed by replacing the motor. It's usually easiest to change the entire sump assembly with the motor. You will have a new wash system. Part number W10782773 Dishwasher Pump Motor Part Number 8535150 Sears PartsDirect

Feb 22, 2018 | Dishwashers

2 Answers

Our dishwasher is making a loud noise during wash cycle.


if you have a torx 20, and torx 15 screw driver, you an remove the screws from the top plate of the wash motor, and underthere youll see another t15 screw converingthe "chopper" assy, sounds as if a seed, of chicken bone, perhaps apiece of glass hasgottne down there

Jan 25, 2009 | Whirlpool GU3600XTSY Stainless Steel...

1 Answer

Noise from dishwasher


Dishwasher makes loud noise in begining. How do I remove lower spray arm to see if something is stuck? Whirlpool DU1055xtpb4.

Jan 14, 2009 | Whirlpool Dishwashers

1 Answer

1 week after installation- is very loud


dishwasher less then 2 months old was really quiet when we purchased now has a loud vibration noise when water is pumping out.

Jul 23, 2008 | Frigidaire 24 in. FDB1050RE Built-in...

1 Answer

Dishwasher Making Loud High Pitched Noise.


How deep do you want to get into this?It sounds like the wash pump motor bearings that are worn.You can pull the unit out flip it over and wd40 the bearings in the motor or you can replace the bearings.Try to lube them first.

Feb 23, 2008 | Dishwashers

1 Answer

Dishwasher Making Loud High Pitched Noise.


A loud high pitch whine while running the dishwasher means that there is something caught in the chopper assembly. To get to the chopper assembly you need to take the racks out and take the pump apart from the inside of the dishwasher. The chopper assembly looks like a metal grate with holes in it. And it might not even be stuck in the grate but somewhere in the pump area due to the water being pumped out, so the best idea is to take the whole thing apart and clean everywhere. However I do not recommend doing this unless you are completely certain you will remember where the screws and gaskets go, otherwise you risk damaging your pump or house from a leak or improper installation. You have been warned.

Dec 25, 2007 | Whirlpool 24 in. DU900PCD Built-in...

Not finding what you are looking for?
Whirlpool 24 in. DU1100XTP Built-in Dishwasher Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Mike

Level 3 Expert

4372 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...