Samsung LN37A550P3F shadow image

Connect your sound from the cable box out to the JVC theater audio in jacks. This will give you sound through the speakers.

By comparing the unnamed TV's manual and capabilities to those of the TH-C60.

Register and download the manual for free at retrevo.com

http://www.retrevo.com/support/JVC-TH-C50J-Home-Theater-Systems-manual/id/318ci575/t/2/

Hi,

• If I understand your question correctly you want to listen your TV on your Stereo system thru your receiver,JVC TH-M606 ** you need to connect "Audio Output " RCA jacks or "Optic cable output" of your TV
  

** to "AUX input " or "TV" OR "Any input" of your receiver ( except Phone ) or "Optic Cable input"
** than just switch to respective mode on JVC TH-M606 RECEIVER corresponding your RCA or Optic connection...
There you go..Your TV sound is on the JVC TH-M606 Receiver..By this means whatever you watch on the TV (tuner, satellite , Xbox ) ,it's sound will come thru your stereo..

• If you want to listen your receiver thru your TV, sorry but it is not a preferable attempt since TV sound system is not a HI-FI quality compare to your nice Receiver..if you really want to do it,try to do the connections given above in reverse..
  

• And,best of my knowledge I am afraid you can not put in progressive mode without remote
• 
  
• Hope this helps!

Take care and please Remember to rate/vote and give me 4 Thumbs Up for me to continue for Helping out the Community :)

hello cn means capacitors d means diode

regards
shaun

Hello, Please get the code here : www.dvdoverseas.com/dvd.htm
www.regionfreedvd.net/

Regards, Jay__bhvrgf

When you say the "TV side" you really mean the Cable or Satellite Box audio, right? There's no digital optical connection intended for the physical TV.

I hope you're not really looking directly into the cable with your naked eye. A safer way to visually check for the presence of red laser is to hold a thin piece of white paper up against the cable and observe the spot.

With your remaining good eye, look INdirectly or hold a thin piece of white paper in front of the the optical port on the JVC to see if there is a visible red glow. Most likely the cable itself is the problem. Make sure it has large open loops rather than tight bends throughout its routing.

Optical digital cables can't be magically wired to copper inputs. NO digital signal can be magically connected to an analog interface and work.

Even if you could do what you propose, how would you control volume?

Why don't you just connect the BluRay to the JVC system and let IT handle the audio to the sub and satellites?

Run an optical cable to the JVC TH-C60's Optical In port. Make sure there are no tight bends in the optical cable as that will degrade its ability to transmit a signal.

check fuse

optical connection in tv is only input optical connection in receiver is only input will not work.need to connect rca jacks to tv's audio out jacks behind tv to any available input in receiver

You must have a source (I.E. line connection from your cable/Satellite/DVD/VCR) going into your receiver....accordianman