How do i replace ink iam 65 and i guess i am having a momen

There is a discount available

Have the engine hooked up to a diagnostic meter to see exactly where the problem is. No sense in replacing a lot of parts when only one or two may be necessary.

if its the original fitted radio contact jag agent with your chassis number found in your log book if its not the original contact radio manufacturer

hello

you need to purchase the print head, p/n QY6-0034-000

but first try cleaning it . use cotton cloth and GENTLY wife off the excess ink, and surrounding area of the print head.

thanks for using FIXYA

may be you speedometer sensor or its pinion is faulty. replace it with new one! then iam sure it will read correct measurment! thanks

ok call pts eletronic there have parts for you tv and there repair board for you

You need to replace the waste ink absorber and then reset the counter. Generally when these errors occur the waste ink absorber needs replacing, if not your images will start to degrade in quality and you will start to see ink splays / splodges appearing as well as random spots and ink patches. In the mean time press RESUME /CANCEL to continue printing.

you need to reboot once.

most likely your print head is clogged up.
could be from the following:

generic ink
not using the printer a long time
or
when the printer says the inks are low, a big print job is done and some air is now getting sucked into the printhead.

also possible the tubes going to the wastepad are clogged up.

you will need to take the unit to a service center for repair, approx. repair if no printhead is needed about $65.

I would only guess to reset CMOS and try updating BIOS from DOS. Altho, i couldn't remember for the life of it the process to update BIOS from DOS....sorry.
-Mike.