Only get zig zag lines in viewing window no picture

There is a dial or a lever that you turn it to. It usually has a straight line picture for straight stitch and a zig zag photo for the zig zag stitch.

put in a new needle
rethread the machine top & bobbin--use every thread guide
make sure the zig zag settings are correct
it's also possible that the machine could have a worn or damaged gear or cam--which would have to be checked at a sewing machine shop

You have the machine set for blind hem stitching. Change the stitch selector to stretch stitch, which is a single, in line stitching zig zag stitch.

Cheers,
Embroidery Services
San Diego, CA

First, make sure you select the straight stitch setting on the round dial. It is the one that has the dashed lines, looking like the stitch itself. Then, you may also want to be sure that the stitch WIDTH (dial with the picture that looks like a straight line gradually turning into a zig-zag) to the lowest setting, which is generally 0. With some machines, even after selecting a straight stitch setting, moving the stitch width can change needle position. Sometimes it will initiate the zig zag, other times it will move needle position left to right. Does that fix it?

Sounds like you have power saver turned on. Go into "display properties" under "control panel". Go to "screen saver" Check your "Power" settings. Un-check "Hibernate" or look and see power settings are and adjust accordingly. If they are all turned off, check your BIOS settings on your PC. It mights have a power saving feature in there.

That Zig zag lines it means that the pictue on your computer is already deleted or missing or may be change the file name., try to right click on the zigzag picture then click locate on computer for you to able to look or search for the picture.

The best thing you can do is Google, singer zig zag, and at the top, select images. You will get about 145,000 hits.

Hi,

This is actually a picture of a tire (tread on the bottom) with exclamation mark

This means your tire pressure monitor (TPMS) has detected a LOW TIRE inflation condition in one of your tires.

Check your tire pressures without delay - warning light will go out after your have inflated your tire.

If it is a horizontal line is straite or zig zag, if it is straite then problem in your vertical section,please check the supply of vertical section or output ic of vertical, if it is zig zag line then it could be dry solder in the yoke connector or vertical yoke open, please let me know the vertical ic no.

when you say distorded, is it like a 3-d effect? or more of zig zag type lines in the picture. If there are color outlines like a 3-d effect, then you are having a convergence preakdown, and are going to need to have the convergence IC's replaced. if the problem is the piture is zagged edges and zig zag, lines or a smearing effect, most likly it is the PIP modle is going bad, and even if you dont use the PIP, the video still goes through that module. If it does not have a PIP feature, then there are bad capacitors in the sweep power supply and the problem will get progessivly worse till the set wont come on anymore. Hope this helps. Good Luck