Hi i'm looking for a manual for a carrier 38rq0 54900-21 and is this system hot and cold

They sell picnic carriers that are really cute as some of them have some great patterns. You can put hot or cold food in and you buy the size that best suits your needs.

Here is an example from the amazon site;

http://www.amazon.com/Picnic-Plus-Entertainer-Carrier-Cosmos/dp/B0062O4OTQ/ref=zg_bs_13789681_18

if you only want cold water for washing, just select cold wash in the program settings and turn off the hot water tap
so the settings you will be looking at are --like --
tub fill ---low water medium water or high water
water temp cold or hot
rinse hot or cold , wash setting --heavy , delicates , whites , woollens etc
may not be exactly worded like that but you get the idea
when ever you see wash temp or water temp , select-- cold

A cold solder joint is a solder attempt that was no heated properly with the soldering tool being used. Most of the time, you can tell a cold solder joint because the solder cools to a dull look; good solder joints look shiny. The solder joint in the picture on the left is dull and you can see there is not good adhesion on the pin terminal for the part being soldered, it was not hot enough for the solder to stick to. The picture on the the right shows a combination of cold joints and lack of enough solder
Hope this helps.

Hi, sounds like you have a cooling flow problem, is the bottom hoses getting hot and the top hose hot or cold. If top is cold you could have a stopped up heater core or a restriction going back to intake. Have you ever flushed the cooling system if not is worth a try and what does your coolant look like in the radiator is it muddy looking or any thing like that. Thanks if i can help further just re post.

Hi There,
Check the fan drive belt & motor. Hope this helps and thanks for using FixYa!

Set the thermostat to COOl and lower the temperature control.

Set thr thermostat to AC instead of HEAT.

If your water is too hot, then either the water tank thermostat or the wiring to the indoor unit is defective. When the water reaches the set temperature, then the tank thermostat contacts should open up and shut off the combustion unit. If the combustion unit does not shut off, then check all wiring and relays. A manual is located at http://www.scribd.com/doc/29550374/Amana-HTM-Plus-Manual

Hi, Had the same problem, checked all possible solutions but my service tech found that the Compressure clutch was not aligned properly. When the engine was cold, the AC was funtionning until sensor stop it but could'nt re-engage after the engine was warm (metal retraction).
He removed a spacer from the polley and problem fixed in 20 minutes!
Rino

I don't have a diagram, but maybe I can help you. You have 2 compressors, o.k. 2 stage system. A single phase contactor? do you mean a single pole, one side breaks, the other is always hot? Speaking of phases, is this a commercial unit with 3 phase? Also, Each compressor needs a separate contactor to carry the load. What is the question?