Misplaced manual. How to assemble Cuisinart Smartpower 7 speed electronic blender- Specifically need to know where to place the gasket.

Yes fixable a number of ways

Remove the blades and punch out the shaft. Clean it all and then reassemble it with lots of water pump grease (it's waterproof). Seizing happens because liquid goes down between the shaft and housing and sets.

Or

You can replace the blade assembly. The link below shows unavailable, but it shows the screw cap.

https://www.pinterest.ca/pin/336644140882543457/

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk01e6oS01kQREtDDo5p3wJFsWtjgLw%3A1606770716337&ei=HGDFX9H3E_ew5NoPp4eroAw&q=Cuisinart+Vari-Speed+CB-4+blade+assembly

Or you can replace the jug and blades

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk024qU5VgFCYIiGjqh6GkrGHAHCokw%3A1606770975275&ei=H2HFX_m1EI7u_QbH9oD4CQ&q=Cuisinart+Vari-Speed+CB-4+replacement+jug

Or Contact Cuisinart direct

blenders parts & accessories - Cuisinart

www.cuisinart.com > ... > Parts & Accessories

Discontinued SmartPower Bar Basics™ 18 Speed Electronic Blender (CB-18BKSS). CB-18BKSS Discontinued SmartPower Bar Basics™ 18 Speed Electronic ... ‎CB-18BK · ‎CB-18BKSS · ‎SPB-7CH · ‎BFP-650 ..

where you got it at will depend on the type it is

hi,

sounds like the bearing assembly went, right where the motor connects to the blade, you can get a replacement base from them, have to find the model number and go to their website. doubt you burnt it up. cuisinarts supposedly are commercial quality.

jm

The Instruction Booklet for your Cuisinart BFP-703 SmartPower Work Top Blender can be found here:

http://www.cuisinart.ca/pdf/ibs/en/BFP-703CHC_en.pdf

Thank you for using FixYa!

when the blender cup is not on, does the spindle turn (medal stud looking thing)

and does it do it on all speeds?

Make sure the gasket is fully seated and not uneven before you re-assemble the base and blade unit.

Check if leaking at the bearing for the blade.

If the bearing has worn, dis-assemble and coat shaft with food-safe grease and re-assemble. Also coat the seals with the grease.

There is probably a hairline fracture or tiny crack in the blade assembly itself - replace the blade assembly - it will automatically come with a gasket, so you will have an extra.

The gasket goes between the cutting assembly and the glass. So you slip it on over the top of the blades and then put the glass jar over top of that. Screw the bottom cap on to tighten everything together.

The thermal fuse is blown. You can buy a replacement from RadioShack for $1.69 You have to remove the old one and solder in the new one. If youre "handy" its very easy. Take it to a repair shop, you pay about the same as a new one. Its too bad that most electronics made today are cheaper to throw away and buy a new one rather than fix them when they break.