Passload 900420-Everything works, lights, fan, etc. but gun won't fire.

replace circuit mold assembly or spark unit its probably the spark unit

When it stops firing is the little light on the side of the handle green or red? If it is red then the battery is draining down too quickly. Either the fan switch has malfunctioned causing the fan to run all the time (I have seen this before) or you got either a faulty battery or charger.

ke sure fan is working after u fire it

I had the same problem... even after cleaning it and replacing the spark plug. ...Only solution was to send it to a service center for repair.

Check Paslode.com for the closest service center to you.

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

././';][

Any time these guns become intermittent or stop firing but the fan still runs, the first the to check is the expiration date on the gas cartridges. The do expire and this will make the gun work inconsistently or not at all.

DO NOT USE WD40 . Is The Nailer fireing? If Not check the micro switch by the fan . Make sure it is pushing on the switch.. Otherwise bend it a little

I would look at the fuel cell on the bottom is a expiration date and they will not fire older fuel. Also do you remove the battery and it does the same thing? When you depress the safety on the work can you hear the fan motor? You say the tool is clean does it have enough lube to move all items freely. Just a couple thoughts, Also look at the spark plug wire for being broke or coming out of the spark unit. Let me know and we will go into this deeper.

ther is a depth adgustment on the front of the gun,try lowering the adjustment tip a little at a time.see if that works.

Make sure that the battery is pushed in all the way in. Sometimes the battery will not make contact and the fan will not turn on. I have had to put a piece of tape over the battery to make it work. Or see if you can bend out the connectors in the gun.