Please, I need to know how to wire a new switch to a upright vacuum cleaner thats already been taken apart. If I wire two wires direct to the motor it runs fine, but there are other wires that I don't know where they go because I did not take apart. If someone can help, thank you very much.
If the switch is still connected the take one wire off at a time and put it on the new switch if you do it that way you can't make a mistake.try and get a wirng diagram from eureka or take it in and let a proffesional do it
It is posible you do not need the other wires have you replaced the original switch for the same or similar some of these switches have lights on could this explain the extra wires? also vacumcleaners sometimes have interferance surpresors they work fine without these but they interfear with tvs etc if not fitted mabe its missing?
233 views
Usually answered in minutes!
×