I have a leak inside my Kenmore Coldspot Model # 106 72104100. It is not coming from the icemaker.

Hi,

please double check that your freezer door is closing properly. You can also pull the fridge out and check whether the water is coming from the back of the of the fridge. If not, then that means there's a leak under the fridge and if that's the case you'll need to schedule a diagnostic on the fridge. You might reach out to Kenmore over the phone directly to ask them to send you a technician for this.

Thank you.

The water supply solenoid valve may be malfunctioning or the fill tube to the icemaker may be mis-positioned.

The model number you listed is for an air conditioner. Please check inside the refrigerator for the model number?

On the bottom rear of the refrigerator as you are looking at it from behind the left side where the water is feeding into there should be a double valve. 1 is for the water and the other to the icemaker. Many times that valve won't shut off, however the switch that dispenses the water is evidentially bad and needs to be checked if it is stuck open.

The inlet water solenoid valve is likely leaking.


Hope this helps?

Most likely ice maker is the problem and would need replacing. Water valve is letting to much water in but the amount of time solenoid stays open is controlled by the ice maker

your mod is probably type with wlect eye , if ice bucket is on door . this is the type you have , and no lever is on icemaker . the problem is with the eye .. replace the eye kit . this is a very common problem . new kit is revised / and works good .. mm feed back pls .

Maybe the heater that releases the ice is malfucntioning. If the heater comes on all to often, the ice would not have enough time to freeze.

DID YOUHOLD THE DISPENSER FOR A LONG TIME AND PURGE AIR ??? ARRE YOU GETTING ICE???

hi debie normaly the life of these ice maker range from 3 to 4 years then the wtr hardness eats them up and the mold start leaking wtr but if is a fairly new model the you have a faulty wtr vale that is not closing sending wtr all the time to the ice maker repl the ice maker is you see is peeling of the texture inside if it is ok repl the valve