How to replace the waste container in phaser 6110?

For me this used to happen quite a lot. Finally I figured out it was because the waste toner container was full.
Buy a new one, or empty it.

it can be full the waste toner, or doesn.t fit after you unloading.

try to replace it

The life of the waste toner container unit is approximately 1,250 pages

for full color 5% image printing or 5,000 images for black printing. When

the life span of the waste toner container has expired, Replace/Install

Waste Toner Tank appears on the display of the control panel,

indicating the waste toner container needs to be replaced. Otherwise

your printer stops printing.

To replace the waste toner container:

1 Turn the machine off, then wait a few minutes for the machine to

cool.

2 Open the front cover.

3 Pull the waste toner container out of the machine using its handle.

4 Remove the container's cap from the container as shown below,

and use it to close the waste toner container opening.

5 Take a new waste toner container out of its package.

Tip

Make sure that you lay the waste toner container on a flat

surface so that the toner does not spill.

Caution

Do not tilt or turn the tank over.

6 Insert the new container into position and then push it to make sure

that it is firmly seated in place.

7 Close the front cover firmly.

8 Turn the machine on.

Caution

If the front cover is not completely closed, the machine will not

operate.

Tip

After rebooting, your machine will automatically reset the
counter for the waste toner container

From the manual:
http://download.support.xerox.com/pub/docs/6110MFP/userdocs/any-os/en/B_Guide_EN.pdf

Click on this link or copy and paste the complete link into your browser.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response. Happy Holidays!

Thanks, Joe

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

I have the Samsumg version of this printer CLX-3160. Sounds like the paper takeup roller is not able to grab the paper. What does the LCD display say when this happens? I don't know what software came with your printer, but Samsung provides a PC Smart Panel software that gives a better diagnostic capability. If you have not installed it, install it and see what it says the trouble is? Hope this helps.

You sure can, until my piece of sh*t 6110 sied yesterday I emptied it weekly (that's for 2 years). It wasn't that that killed it, the imaging unit went.

Is the waste toner cartridge full? If so you can vacuum out the waste toner and re-use the container. The waste container is on the left hand side with the front flap down.

check the waste toner (it's on the left side of drum unit when you open the front cover) cartridge or paper jam if blinking!

Hello there :
in the main menue of the printer there is a option that lets you reset it to zero but if this is a buisness printer you might have to have the company come and set it for you cause theire somtimes is a code that is entered to get to the main menue

That machine does not have a waste toner container like the xerox phaser 7400. What it does is all the waste toner is cleaned at the IBT belt. If you remove your IBT belt part number 016-2000-00 you will see there is a plastic container at the end and that is where the wast toner is.