At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Tv screen when powered on is green and is in mono...
Hello,
This sounds that the crt in your tv may be faulty but to be certain and investgation with some test equipement is required , does the fault clear as the set warms up.
regards Derrick
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
LG 141K TX) Manual Online: Tv Speaker, Stereo/dual Reception, Nicam ... Stereo. Dual. Mono Sound Selection. In stereo reception if the stereo signal is weak, ...
It sounds like there must be a bad connection on that input. Try switching the left and right input cables for the TV and see if you get the left cahannel working. If so, investigate a possible bad cable or output issue from the TV.
Make sure that you have connected the cable box properly to the TV.
Use the audio and video OUT from the box to the TV IN.
Select the correct input on the TV.
Connect it using any of the following: A HDMI cable (1 cable for both audio and video), Component Cables (3 RCA's red, green, blue) + RCA audio cables (1 for mono or 2 for stereo), S-Video + RCA audio cables (1 for mono or 2 for stereo), or AV cables - 1 RCA for video (usually marked yellow) + RCA audio cables (1 for mono or 2 for stereo).
Consult your TV's owner's manual for detailed instructions or ask me for more information.
You should be watching your dvd's on an input and not on tv analog 3. Every time the tv "senses" a signal change in the audio that screen will pop up. Connect the DVD player to the tv by using either the red, white and yellow (composite) connections or using the green, blue, red, white and red (component). Once you are on an actual input that box will stop popping up.
With your tv on and the green K box on your left.
*unplug your tv from the outlet
*HOLD DOWN the (Volume - and input)
*Holding down the (Volume - and input) plug tv in
Tv will power on.
Now Tap the (Volume - and Channel -)
you will go in a menu tv mode
with the "remote" hit the down in the arrow (not channel or volume)
Now hit (volume +) and the tv will get arrows ex.(/////////)
The tv will turn green "meaning it was resetted"
Unplug tv from the wall.
Wait (30 Seconds)
Turn tv back on.
Since the Tv was resetted, go through the initiative Welcome startup screen. (Pick your Language, etc..)
using a dmm check the resistors on the kine board. the small board on the back of the picture tube. you sould find an open resistor. if i remember correctly, if looking at the back it would be on the bottom of the board & about 180k ohm. if you have a difficult time finding it, look for the same type/color of parts on the small board to make comparrisons. between parts. you sould have 3 of most parts, one for each color.
good luck.
×