HOW DO I CHANGE MY BATTERIES IN MY MIDLAND LXT303 RADIO

https://midlandusa.com/two-way-radios/support/owner-manuals/

Are batteries installed in the proper configuration? That is; plus to plus terminal, minus to minus terminal. Are batteries charged? Check with voltmter.

Hi Basto,

What does not communicate with what device?

You need to give as much info about what it is that causes the problem.

The more info I receive, the easier for me to assist you.

Please reply with as much detail as you can, so I can find a solution for.

Regards,
Peter

• The Hi and Low power are built into the radio and is dependent on the frequency/ channel you are on. Hi power is 1 Watt and Low power is .5 Watt. The radio is GMRS and FRS. The FRS are low power and the GMRS are Hi power.
• Channels 1-14 are FRS frequencies and Low power.
• Channels 15-22 are High power and are GMRS frequencies.
• FRS = Family Radio Service.
• GMRS = General Mobile Radio Service.

• If you have any comments please feel free to leave them here.
• Hope this helps and thank you for using FixYa.

Regards, Tony

they could be set to the wrong tone or channel.

Here is a link to the Manual for the Midland LXT-330
http://www.midlandradio.com/comersus/store/catalog/LXT330OwnerManualRevC.pdf

HiTech Wireless

Set your interference eliminator code on the T5720 and the Qt filter both to zero. You have one or both turned on. By setting them to zero you will turn them off. Then your radios should work together.

I changed out the batteries with new ones in radio " A " and now i no longer have any feed back!

Hi,

There could be three (3) reasons why the display shows the battery icon at the top left side of the LCD display:
1. weak/undercharge/discharge batteries;
2. dirty/corroded/loose battery contacts/terminals; and/or
3. internal fault with the electronic sensing for battery level/state.

Corrective measures would require:
a. replace/recharge batteries. The rechargeable batteries need at least 12 hours of charging time;
b. clean, scrape, tighten (need to bend a little more towards the battery terminals) the spring/contacts of the battery holder;
c. (on the internal fault) your best bet might be to seek the services of a professional electronic technician since this would need familiarity with electronic components, their circuitry and diagnosis, perhaps a bit of soldering and the use of a DVM.

On the other hand, if the "low" is the "L" icon at the bottom right side of the display, this would indicate that the radio's transmit power setting (H/L - high/low). Transmit power level can only be changed in Channels 1-7 & 15-22. The radio will also auto change to lo power when batteries are weak.To switch to high power, press on the Menu button thrice or till "Pr" icon shows, press on the up/down to select H or L. To save & exit, momentary press the PTT.

Hope this be of help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Hello
This could be the Ptt Switch , Midland is 3 Years warranty try to claim the warranty, this is a Factory fault.