MY CAMERA SHOW E03 ;unit in safeguard mode ;EJECT AND REINSERT TAPE WHT SHOULD I DO............

Get it fixed

Step 1 Look at the camcorder's display to identify if it is in Safeguard Mode. If its display indicates an error number of E01 to E06, your camcorder is in Safeguard Mode.
Step 2 Disconnect your camcorder from its power source and remove its battery by sliding the latch forward and sliding the battery down while pulling it away from the camera's body. Wait at least two minutes before continuing.
Step 3 Remove the camera's cassette by pressing the "Eject" button, waiting for the cassette door to open, and lifting it out of the tape bay. This step is only necessary if the camera indicates the E03 or E04 error code or it tells you to eject and reinsert the tape.
Step 4 Replace the camera's battery, power connection and cassette, and turn the camera on.

my jvc camcorder kep.s saying unit is in safeguard mode eject and reinsert tape have done this a dozen time still show,s same thing on screen would appreciate help thank you larryd i

I GOT

cvslkjsdflkds

According to http://www.techlore.com/article/10974/JVC-Camcorder-Stuck-in-Safe-Mode/,

"JVC notes that you are also given a malfunction code when the unit is placed into safeguard. If it displays code 01, 02, or 06 you should remove
the battery and powersupply and wait for a while. Code 03 and 04 indicate that you should eject and reinsert the tape.

If neither of these solutions work, your only alternative is to bring it to a shop or send it to JVC for diagnosis or repair. Unfortunately, there is no other way to clear the condition."

If you are getting E03 or E04 errors on every tape you try, it sounds like a servicing is required.

I can't find e setup for sony
camcorder

Take out the battery to clear safeguard mode , if this does not work, the unit is defective and should be taken to service.

There should be a error code,what is that?

your tape transport is bad