Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne Logo

Question about Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

2 Answers

My eletrolux ergorapido will not hold its charge. Can't find a new battery. Where to I go to get one?

Posted by tlaue on

  • Don Richards May 28, 2012

    I ended up putting 9 of the 10 batteries and it works great. Much better than orriginal batt and laast much longe batterr lifer with kisk but speed . Love my toy. Wish I had hooked ut the 10th batterry now and there is room if you play wyrh the wires just rirht.



2 Answers


  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

You can get new battery from amazon. Take a look here Replacement Battery Pack for Electrolux Ergorapido 2 in 1 Stick and... , that was cheapest (with good reviews). I hope this was helpful. cheers

Posted on Nov 25, 2014



  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,418 Answers

Let me say this; The battery replacement for the PRONTO is not a owner level replacement procedure. However, you can replace the 4 original EMX1600sS batteries . The battery model is Tenergy 2/3A Size Rechargeable Battery 1.2V 1600mAh NiMH W/ Tabs Those are a little smaller than the originals but with the same capacity of 1600mAh and can be easily found in the web. Anything under those specs should work.

Posted on Jan 27, 2011


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:


I lost my charging station, where can I get one

If it is from overseas, is her voltage the same as yours?

Parts are available for most.


make model parts
make model charging station

Where do I plug the charger at to an ergorapido by Electrolux

Which model do you have? The Ergorapido EL1014A has a charging station. On that model, the charging adapter plugs into the port on the bottom of the floor section of the charging station. This port is below the wall section of the charging station. For the Ergorapido Lithium Ion Plus 2 in 1 vacuum, EL2055B, the charger plugs into a port on the back of the main vacuum above the neck to the roller brush head. For a picture of the charging port location, see https://moderncastle.com/vacuum-cleaner-reviews/electrolux-ergorapido-vacuum-review/ . Scroll down to the Battery section to see the appropriate image.

I hope this helps. The manual for the EL1014A is much clearer about charging the vacuum.

Cindy Wells

My Electrolux Ergorapido Lithium item number on vacuum SNES321602000476 won't charge it shows a orange light for a second then nothing? Won't work?

Iy is either the charge or batteries, if you have a DMM or access to one test the charger by measuring output,
best solution is to change e batteries and charger, You can look in line amazon sell both, but may be less on eBay, Watch this link


Red light comes on after charging my ergorapido

I had the same problem. Red light would come on after charging was complete. On investigation I found that there is a small gray wire that runs from the rear batteries to a large solder spot on the control board. Upon re-soldering this wire I got an additional 3 V of power and the red light does not come on anymore after it is charged. I can vacuum the whole house and then some and still not run the batteries down.
Jan 15, 2013 • Vacuums

Electrolux 2 in 1 Ergorapido stick Vacuum. Motor runs then cuts out after 3 - 4 seconds. Sometimes it will run properly for 10 minutes so batteries are good. Why does it cut our usually?

If the hand held is working correctly (By itself) try pulling up a little bit on the 4 metal connection tabs on the wand. The connection tabs were not making a proper connection on my unit.

I have a 2 year old Electrolux ergorapido cleaner that gets used daily for about 2/3 min, the blue light on the stand comes on when the cleaner is put on to charge but fades after about 5 min & the...

No, not worn out batteries.
For my experience, if the batteries were worn, they would charge with the blue led being on and after that, the vacuum wouldn't hold his charge. just that.
This is a different problem. Check the contacts between the charging station and the vacuum, mines got bent a bit and stopped making contact. This has happened twice and just fixed it about 30 min ago. That is why the led first lights and then goes off, there was just a brief contact between them.
Nice vacuum, very powerful and handy but maybe it is just poorly made as it is engineered in Sweden but built in China.

My electrolux ergorapido wont power on . Have only used it a few times. It has been on the charger for approximately 2 weeks without use.

If it will not come on there are several things you need to check. First off you should call and have your model type and serial number checked to be sure your unit isnt affected by the recall they had due to expanding batteries. Second you do have a 2 year warranty on the unit and if it wont even turn on there may be a defect. Are the blue charging lights coming on? If they are and your transformer is warm then there is more then likely a defective battery in the unit and you should contact customer service at 1800-896-9756

Ergorapido: light doesn't come on when vacuum is put on charge

If it is new, take it back and get a different one, either the charger or the battery is bad.
Mar 26, 2008 • Vacuums
Not finding what you are looking for?


Ask a Question

Usually answered in minutes!

Top Electrolux Vacuums Experts


Level 3 Expert

85240 Answers

David Shaub

Level 3 Expert

2994 Answers

john h

Level 3 Expert

27461 Answers

Are you an Electrolux Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides