Face when the face is closed its workin fine but when opend it doesnt operate , useing the remote it works fine but as remote doesnt have eject its been same cd for months

Here are some general instructions for operating a TruTech T-350 CD player:

Press the "Power" button to turn the CD player on.

Press the "Open/Close" button to open the CD tray. Place a CD into the tray with the label side facing up.

Press the "Open/Close" button to close the CD tray. The CD should start playing automatically.

Use the "Play/Pause" button to pause and resume playback.

Use the "Skip" buttons to skip to the next or previous track.

Use the "Stop" button to stop playback.

Use the "Eject" button to eject the CD from the tray.

Press the "Power" button to turn the CD player off.

Try an other code. some codes might work with all function buttons.

There is no eject etc button on the remote control because what use would it be? To insert or change a disc, the operator would have to be in reach of the drawer with a disc to hand.

had the same problem with my alpine, i was able to fix it once by, popping off the face plate and with fine grit sand paper (lightly) sand the connection points on the radio and the face plate, then put a little bit of dialectic grease on it . also doing a reset on the unit helped me from time to time...

There is a indent in the front of the face of the radio. Try to push it with a sharp pencil or pen. It might reset the cd part and eject button might work again. If not you may have a cd stuck in it then you can try get tweezers and pull it out or a credit card and try to straighten it out. Those were some of the techniques I used when I was an installer for 12 yrs.

DUDEEE this exact same problem happened to me!!!! what happened was it was workin fine then it started turning on and off, then now it goes through these weird phases where i cant turn it off using remote or the power button. every button on the side of the tv and the remote doesnt work. so i have to unplug it to turn it off, what a messedup problem!!! im taking my LG 32LB9D to the tv shop tomorrow i hope to get it assest and possibly fix, ill tell u how to solve the problem if my tv is fixed. :)

Use different tape. Is the tape still attached to the feed spool, or has it become separated ?

yes it is a over heting problem

Both remotes are operating on the same frequency - usually you would think that having two products of same manufacturer would be a good idea, but in this case, the remotes interfere with each other.

u need 2 replace the ribbon that goes to the panel to the unit.i had the same problem with mine then i went on to ebay and found the ribbon there (cdx-m8800 repair kit)hope this helps