I understand your problem. If u set the lamp properly then It may cause the lamp circuit need repair. Have you got yellow lamp indication before change the lamp? If occur then you have been late to change it. If you used it up to 2500hrs. then this problem may arise. check those first if everything ok
then may be the circuit have some problem, go to the nearest sharp authorize service center. or visit website
Ravi,
I just read the manual for the projector. It clearly says that the lamp, if used for more than 2400 hours, will send the projector into standby mode. And then it should be taken to the nearest Sharp Service Center. Please do that. It means that the breakout from the standby mode is very technical and should be handled by trained technicians of Sharp.
164 views
Usually answered in minutes!
i have tried the reset sequence mentioned in the Manual ( power on, input, undo, left, enter, right, power on) but it does nothing is there another way to hard reset the projector lamp timer. The lamp is out of warranty so i am ok to try anything before i take it to sharp. I am fairly technical so any instructions would be ok
×