LCD monitor image

I had that problem, after awhile of using mine, the words would appear to be streaking. I bought a new monitor.

Unfortunately it sounds as though your monitor is slowly dying on you :\ Though i must say its a very strange way to have it go.

It transfer the universal image signal of TTL and LVDS signal to specific TFT LCD.
No offense, but it is a very complex subject.
Unless you're an EE.

Well in monitor you can do one thing - disconnect the monitor cable*(VGA Cable) from the tower and chk still if u have the same faint screen that means monitor gone bad if not than uninstall the Grapics Driver and shut down computer... if u have internet than restart and go to device manager ( Run - devmgmt.msc) under display adapter right click on grapics name and update driver.

Check the video card first, if you have another vidoe card try it. If that does not shore up the problem the monitor would be a issue, and now a day monitors are dirt cheap even for the LCD monitors so I would look into buying on of those if your inclined to do so.


Rulds2008

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

My grandson suggested I unplug the computer from the wall and leave it out for a while. i did, and it worked!

This sounds like a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check the following two links for more info:

http://camerarepair.blogspot.com/2007/11/canon-digital-cameras-showing-black.html

http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&fcategoryid=225&modelid=13390&keycode=2112&id=29819

Applicable cameras include:
A40, A60, A70, A75, A80, A85, A95, A300, A310, S1 IS, S60, S200, S230, S330, S400, S410, S500, SD100, SD110, IXUS V2/300/400/430/500, IXY Digital 200a/300a/400/450/500

Try removing signal cable and refitting at both ends.
Signal cable also could be faulty.
Samir

tell me in briefly

Sounds like an inverter problem. If the power supply is internal replace the capacitors coming out of the voltage regulators. These are usually 1000mf and/or 470mf. If that doesn't do the trick look up the numbers on the 8-pin chips that drive the secondary transformers on the inverter to see if they are getting the right voltages.
Good Luck!