Sir, whenever i tried to take a print, print is coming but so many white & black lines are also coming & left side print is fading. pls help me out.

I do not know for sure but it sounds like the paper is not griped properly, this would cause the jagged lines. I would try another ink cart when the loose paper problem is resolved. I hope this helps.

If you remove the toner cartridge and gently shake it side to side, then reinstall it, does the problem go away, or come back after a few pages? I would suspect you have a bad toner cartridge/image unit and recommend you put in a new one.

You may have an element or two on the left side of the printhead that is worn out and not printing. The best way to see if elements are not working is to use the widest label you have and run the PAUSE test. Turn the printer off, press and hold the PAUSE key while you turn the printer on. Keep pressing for about 10 seconds and then you can let go. When the printer is finished starting up, a test pattern will print. Part of the pattern is a black box. Any elements that are not working will show as white vertical lines. The only way to correct is to replace the printhead.

Hope that helps !

This is coming from the Black Drum Unit. You may be able to remove the unit and look into the slot on the top. You should see the drum which is green in color and may be able to see the lines. Not much you can do with these units so you may just have to replace it.

Clarion uses the industry standard wiring colors. Not every unit will have all of the listed wires

SPEAKERS:
White = Left Front +
White/Black = Left Front –

Gray = Right Front +
Gray/Black = Right Front –

Green = Left Rear +
Green/Black = Left Rear-

Violet = Right Rear +
Violet/Black = Right Rear –

POWER/ACCESSORY:
Yellow 14ga = Battery Main/Memory
Yellow 18ga = Battery CeNET Power/Memory
Red = Accessory (ignition on)
Black = Ground
Blue = Antenna Turn On +
Blue/White = Remote Turn On (amps) +
Orange/White = Dimmer
Brown = Phone Mute
Orange or Mint Green= Parking Brake Video Lockout
White/Red = CCD (camera) input instant on +

RCA Cables:
Gray = Front Output
Black = Rear Output
Purple = Non-Fade or Subwoofer Output

Hello sir; When you make copy is through by ADF? make another copy leave on the glass, compare both, is that same with the line then you have to replace drum blade, if first one with the line and second one without the line, then you need to clean a narrow strip glass on left hand side of the plateform.

Hello sir; Believe or not , you need to replace imaging unit.

Clarion uses the industry standard wiring colors. Not every unit will have all of the listed wires

SPEAKERS:
White = Left Front +
White/Black = Left Front –

Gray = Right Front +
Gray/Black = Right Front –

Green = Left Rear +
Green/Black = Left Rear-

Violet = Right Rear +
Violet/Black = Right Rear –

POWER/ACCESSORY:
Yellow 14ga = Battery Main/Memory
Yellow 18ga = Battery CeNET Power/Memory
Red = Accessory (ignition on)
Black = Ground
Blue = Antenna Turn On +
Blue/White = Remote Turn On (amps) +
Orange/White = Dimmer
Brown = Phone Mute
Orange or Mint Green= Parking Brake Video Lockout
White/Red = CCD (camera) input instant on +

RCA Cables:
Gray = Front Output
Black = Rear Output
Purple = Non-Fade or Subwoofer Output

clean the scanner unit mirror

If the colors are good and solid with no fades, only black streaks, then black is the culprit. I suggest replacing the black cartridge.