Get Unable to print 32 error message. Can I fix this or does it require a tech?

how to solution 5a print unable pring Dcp 125 prin

The messages unable to print, unable to clean, unable 36, error 46 and error 32 are all print head errors.

1. Remove all the ink cartridges from the machine
2. Clean the contacts on the cartridges as well as inside the machine itself with a small amount of warm water or alcohol on a cotton swab until no ink comes off on the swab.

Note: if any of the other cartridges are low, empty, leaking or bulging replace them

3. Then turn off the machine and unplug it for 70 seconds
4. Plug it back it and wait for the insert cartridges message
5. Insert the cartridges and check to see if the problem is still there. If it is it means the print head has failed and in order to fix this the print head inside the printer needs to be replaced. The print head is the part of the printer that puts ink from the cartridges onto the page

Unfortunately this can sometimes cost more to replace then the machine itself.

The message "Print Unable 32" or "Machine Error 32" will appear on the LCD display if paper or labels are stuck inside the printer or drum unit.

Follow the below link to fix Print unable 32 error message on Brother MFC-9840CDW Laser Printer

http://tinyurl.com/print32
All the Best...

Just click on the below link to fix "print unable 32"
http://welcome.solutions.brother.com/BSC/public/eu/eu_ot/en/faq/faq/000000/002500/000055/faq002555_000.html?reg=eu&prod=hl4040cn_all&c=eu_ot&lang=en

Service Manual can be found here. Free
http://hotfile.com/dl/28988134/55113fe/CLX-3170-3175.zip.html

I have a Brother MFC-440CN fax machine and I am receiving error message "unable to clean 50". Can anyone help me to fix this error problem

Unplug the printer from power cord.Press and hold the "menu" button, then plug the device.You'll see on the LCD screen a "machine error" code.If this code is 40,41,49 or 4F the print head is defective.If the error is 48 - defective print head cable or circuit board.If the error is 50 or 51 there is error in Purge unit and printer require service.If the error is 46 the waste ink tank is full.Follow this:
Enter 80, then scroll down with the arrow down (round) key. You'll find an entry listed as purge count. If number is over 6000, enter 2 7 8 3.This will reset the purge count value. Then restart the printer, hopefully without the annoying cannot clean message.

The message "Print Unable 32" or "Machine Error 32" will appear on the LCD display if paper or labels are stuck inside the printer or drum unit.

Follow the manufacturers recommendations on how to clean the rollers, etc.
Read the users manual.

Print unable 32 is dirt or scratch on the transfer belt assembly. There's a timing mark on the belt that a sensor must read. If the belt is damaged, you will need a new one.