When using the dryer I constantly get the 5e error flashing. What do I do to fix it?

I can find no code 5E listed. Check for yourself Kenmore Elite Dryer Error Codes Sears PartsDirect

https://applianceassistant.com/ServiceManuals/5995393146_frigidaire_27_inch_dryers_gas_and_electric_electronic_controls_service_manual.pdf
This link gives error codes for dryers.

I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

About 64,200 results (0.62 seconds) Search Results

Fixing a broken Samsung Microwave - The dreaded 5E ...

? 4:30
https://www.youtube.com/watch?v=_yWSU0kTkTg
Mar 20, 2013 - Uploaded by Joe Devlin
When my Samsung Microwave was just over a year old it failed giving me an "5E" or "SE" Error code which ...

Samsung Microwave SE (5E) Error Fix - YouTube

? 9:23
https://www.youtube.com/watch?v=YubSrHE7WFc
Dec 7, 2012 - Uploaded by eric hatch
I had pretty much decided to throw it away since the cost to fix it by a ... Fixing a broken Samsung Microwave ...

Samsung Microwave SE Error FIX! - YouTube

? 1:33
https://www.youtube.com/watch?v=oPQE2oLTR3o
Jan 26, 2014 - Uploaded by jjthetechguy
I am not responsible for any damage done to your microwave*** ***Do at ... Fixing a broken Samsung ...

The code is 5E
If your dishwasher is displaying error code 5E, It can be caused by a kinked drain hose.
If the drain hose is kinked, there will be an excessive amount of water in the bottom of your dishwasher after a cycle has been completed.
In order to access the drain hose you need access to the back of the dishwasher. If your dishwasher was recently installed, contact the installer to move the dishwasher and inspect the drain hose.
If the drain hose is not kinked, but your dishwasher is still not draining, service is required.

5e error means drain error the pump has failed or there is something blocking it.

Error code 5E is the code telling you that you will need to clean the filter. After you clean the filter the code will go away.

5E - WATER DRAIN ERROR

5E is displayed if the water level frequency detected is 25 KHz or less in the initial phase of the UNB -detecting cycle. The Water Drain error can be cleared by turning POWER SW OFF and back ON.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

5E - WATER DRAIN ERROR

5E is displayed if the water level frequency detected is 25 KHz or less in the initial phase of the UNB -detecting cycle. The Water Drain error can be cleared by turning POWER SW OFF and back ON.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

possible pump problem
try cleaning out the filter