I nneed that part. - TDB292LF - ACER INVERTER BOARD FOR AL2416W

The problem is in your old computer, the video graphics card is faulty, you mentioned the monitor was hooked up to the new computer and worked fine.

change the serial cord or the videocard. if not work your Acer AL2416W i think your lcd have a problem?

This Acer 2416w has problems with weak capacitors on the inverter board causing shorting of the driver FETs. Replacing caps and shorted FETs may solve the malfunction.

You may have either dying power supply or the backlight inverter board, need to check the voltages, DC filter caps.

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

It most likely is. This is not a difficult repair and you can get an inverter for $10 - $20 off Ebay.

I found C34, C35, C36 and C38 (all 100uF 35V) caps with their bottoms blown out due to over voltage. I suspect Q4 and Q6 to be the culprits. They are both short circuit. F2 found open circuit.
All of the above are found on the backlight inverter PCB.
My problem is sourcing Q4 and Q6. No data available on these devices.
Any help would be appreciated.....

Hi my name is Eric,
Probably not recall status yet, but could get there eventually
　
　
　
If I have helped you with your issue please click accept.

Thanks
Eric

I’m happy to help further over the phone at https://www.6ya.com/expert/eric_ab7c09ec01841771

This Acer 2416w has problems with weak capacitors on the inverter board causing shorting of the driver FETs. Replacing caps and shorted FETs may solve the malfunction.
Monitor Mike

I have 2 Acer AL2416W monitors that i have been using for 2 years. There has been a handful of times i would turn my computer on in the morning and the screen would be black and Acer would lightly flash on the monitor 1 time. Typically a restart would take care of the problem. Last week the monitor blacked out and i can't get it to work. Any suggestions?? I switched ports on the computer to verify it wasn't the video card and tried new DVI cables to verify it wasn't those? Is this fixable??

open the monitor observe smps capacitor in primary filter may leackage if faulty replace it