I am looking for the manual that would tell me how to reset the codes in my keylsee entry locks

Go to your owners manual It tells you how to do it

You must have all remote entry transmitters (maximum of four) available before beginning this procedure. According with the Mariner Owners Manual check this procedure to reprogram the remote entry transmitters:

1. Ensure the vehicle is electronically unlocked.
2. Put the key in the ignition.
3. Turn the key from the 1 (LOCK) position to 3 (RUN).
4. Cycle eight times rapidly (within 10 seconds) between the 1 (LOCK) position and 3 (RUN).
Note: The eighth turn must end in the 3 (RUN) position.
5. The doors will lock, then unlock, to confirm that the programming mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 1 (LOCK) position after you have finished programming all of the remote entry transmitters.
10. The doors will lock, then unlock, to confirm that the programming mode has been exited.

Note: If all remote entry transmitters are not present during the programming procedure, the missing transmitters will not work with the vehicle following programming.

Hope helps.

go to motorcraftserv.com there you can navigate to owners manuals and i do recall a solution that tells how to reset door entry code

Since you have the model number, you should be able to call Schlage and they'll tell you how to reset it.

Tells you in the owners manual.

Don't have one? (Helm.com) Buy one.

look for the permanent code on the plastic card in the owner manual packet. Or, pay dealer to extract code from computer.

Keyless Entry Keypad Code Programming NOTE: The system only allows one code to be programmed.

1. Enter the permanent factory keyless entry keypad code.

1. Press the 1/2 button within five seconds to activate the programming mode. Holding the 1/2 button for more than two seconds after activation will erase the stored customer code . The door locks will lock, then unlock, confirming the code is erased. The existing code will not need to be erased to program new a code.

1. Within five seconds, enter the new five-digit keyless entry keypad code. The door locks will lock and unlock to confirm the new code is programmed.

i want to change code to safe

If you open trunk and look on inside of trunk where hinge bolts are you will see code numbers . Owners manual will tell you how.

do you know the keyless entry code???? if not you can fine on the door lock module that is located inside the back panel where the jack is on the driver side in the back...take that cover off and look at the black box towards the front of the opening and pull the plastic..with a flashlight you can see the 5 digit code on a sticker on that module..that is your code..hope this helps...

look on the sticker located inside the outer panelo on the lock. you are going to need to disassemble the unit but it is in there.