How to set up tony hawk shred board. on the tv it says to connect the board, and the light on the board keeps blinking green

First turn on the little box you plug into the usb of the wii,then turn on board after make sure the wii sencer bar is also able to pick up board as well the red light will flash just let it go and should work make sure the blue lights are on on the board.

http://www.youtube.com/watch?v=Zp311lU2Ejs
If that doesn't work, there have been many reports of users being unab;e to calibrate because of the lighting in the room (too bright, too dim, both can affect the sensor), lighting from the TV (again, too bright or dim). Try turn the board parallel to the TV, so you'll be side on to the TV.

What worked for me after returning 4 times was to set the sensor settings in the wii settings to below the tv but put the sensor above the tv with 2 old and 2 new batteries

At last! My Son's Tony Hawk Shred board was one more try from being thown down the garden, as i have been trying since Christmas day, & finally there it was a board i could use. I've followed all bits of advice in a number of differant ways --- here's what worked for me, Turn off at the wall Sky TV, Turn off all lights (only tv turned on), put my crutches in another room (because large metal objects interfere with soft ware), Remove dog from room, Put senser bar on floor, Turn Wii console side on so that Dongle faced away from tv (aiming into centre of room), Place Shred board on floor facing tv/senser at about three feet away. Start process of game set up untill you get to choose a profile, Select profile, press & hold for 5 secs start button on board untill the four blue lights start to flash at a rate of about one flash per sec, then hold on same button untill blue lights flash quickly, then press & hold Dongle button untill Dongle light stays on, with in 2 secs game calibartion instructions start, BEWARE Tony Hawks responce when process starts is as annoying as not being able to get board started. Good luck when up & running it is one Awesome game!

try using two old batteries and two new batteries, also why calibrating try putting the board on a small stool - this worked for us. Good Luck!!!

turn all the lights in the room the only light is the tv that should do it.

i've got the same problem, as well do about 90% of other people who got this for christmass. like me. i'm about 2 monutes from saying **** it. i try like 20 times every other hours, i've done all the tricks, but they may work for you

use old batteries, try with no light on, try with alot of light on, try it on a stand, try it on green eggs and ham.( sorry humor to lighten the mood)

Use older batteries. Do not use the batteries that came with the board. After you switch the batteries re-calibrate and it should work fine.

I had the same problem. Do not use the batteries that come with the board. Use slightly older batteries and re-calibrate the board, this should work.

i had this same issue try turning off the lights leaving only the light from the tv....worked like a cham for me!