I have a cd player two years old KDC-MP528,
After changing battery on the car in order to make the radio or cd payer work is by pushing one little bottom and this last approximatelly 30 minutes then it will go off. could you please tell me how to reset it? thank you.
To be connected to your ignition if so then unplug the cd first and them
your battery in this sequence negative first then positive and wait ten
secs.then reconnect with positive and then negative and then replug the
cd player...
hope this may help;.
Kenwood KDC MP528 CD RECEIVER REPAIR Manual may help
http://www.tradebit.com/filedetail.php/3112431-Documents-eBooks
Hi, you will need to enter the security code.
This is a
standard procedure we use to bypass the code when we have the gear on
the test bench for repair. Try this and it should sort out your
problem
You need the remote control to do this, if you don't
have one, then you may need to go to a KENWOOD agent and get them to
clear the code for you, or purchase one for your use.
KENWOOD KDC SECURITY CODE CLEAR procedure
Your code number is 5227 (KCAR)
*
Press numeric key “5” ( 2 times ) and press the Track
UP/Next Track key
* Press numeric key “2” ( 3 times )
and press the Track UP/Next Track key
* Press numeric key “2”
( 1 time ) and press the Track UP/Next Track key
* Press numeric
key “7” ( 2 times ) and press the Track UP/Next Track key
Your radio will require one of the following procedures.
Type 1
During the code request mode, while holding the
DISP key depressed, press and hold the Volume UP or DOWN key for 3
seconds (so that “…” disappears).
Then using
your remote enter your code.
Type 2
Press the "Auto"
button and "Track up" on face of radio at the same time.
The four dash lines ( . . . . ) should "disappear".
Then
using your remote enter your code.
Type 3
Model# DPX-4020
and DPX-4030
Press and hold the 1 then the 6 preset key (preset
keys are the buttons on face of radio for storing you "favorite"
radio stations). "C" should display.
Then using your
remote, enter your code.
Enter your number from the
remote control unit. Your code number is 5227 (KCAR)
* Press
numeric key “5” ( 2 times ) and press the Track UP/Next
Track key
* Press numeric key “2” ( 3 times ) and
press the Track UP/Next Track key
* Press numeric key “2”
( 1 time ) and press the Track UP/Next Track key
* Press numeric
key “7” ( 2 times ) and press the Track UP/Next Track key
The security is canceled and the set enters the TUNER mode!
:) POSITIVE FEEDBACK :)
A FixYa rating would be fantastic for helping you out
with this techo tip.:)
A FixYa vote is a great reward for the challenge of solving your problem
ask Robotek
192 views
Usually answered in minutes!
if the solution works i am fine but if it does not work i will not accept this solution
the problem was not solved you need to give it in detail from starting the car since the radio does not turn on normally you must explain please otherwise I will not pay for something that it did not work. thank you
×