Question about Whirlpool LSQ7533JT Top Load Washer

Open Question

LSQ9564JQ0 - washer squeals during wash cycle

Posted by on

Ad

5 Suggested Answers

catriver

Ron Marek

  • 878 Answers

SOURCE: washer make a clicking noise

Zoobs, you could have something stuck under the agitator. The agitator will pull straight off. Grip it on each side and pull up hard, but don't hit yourself in the face. If that don't work, try slipping a belt under it and pull. Check for something caught under it. Another possibility could be the nylon suspension rod socket supports in the back. They will make a noise during agitation if they are dry. Put a little 3 in 1 oil to quite them down. Take the front panel off and check the pulley and belt, see if anything is out of whack. I also often find the motor support hitting the bottom panel during agitation making noise. Take the front panel off and observe during agitation. See if the support is striking the bottom. If so, just bend the bottom panel down. Catriver..post back.

Posted on Dec 01, 2006

Ad

Anonymous

  • 4 Answers

SOURCE: Squealing noise during spin cycle

The spin cycle activates the fast mode on the motor, squealing normal occurs due to belt slippage. I would check your belts (look for cracks. Check the belt tension as well, most washers have an adjustment, normally on the motor that allows you to increase the tension of the belt.

Posted on Jul 08, 2007

Ad

Anonymous

  • 67 Answers

SOURCE: loud squeal during wash and spin cycles, maytag atlantis washer

Squealing normal occurs due to belt slippage. I would check your belts (look for cracks. Check the belt tension as well, most washers have an adjustment, normally on the motor that allows you to increase the tension of the belt.

If part of a belt gets torn and it is long enough, it will hit any part of the washing machine within range and make a clicking noise at every revolution of the motor.

I am pretty sure you need new belts. You should be able to remove a few screws and open the back cover. Between the pulleys there is a tensioner...loosen that so you can remove the belt easily. replace it with a new belt and adjust the tension.

hope this helps

Posted on Feb 23, 2008

Anonymous

  • 110 Answers

SOURCE: Maytag Performa PAVT920AWW washer makes a squealing sound

i am sorry but i had this problem happen before with my customer maytag performa, what i found out is that the brakes become crystallized, causeing a squeaking noise, remember in agitation, the brakes stops the the drum from spinning, what i advise you to do is change out the breaks or take the brake pads and rub them with sand paper

thanks

Posted on Aug 23, 2009

dennis dodge

  • 1891 Answers

SOURCE: washing machine makes squealing noise during the

when belt was changed did you find the old belt to be oiley . it maybe leaking oil from trans . and the belt will keep failing till oil leak is corrected.. mm

Posted on Dec 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loud squealing noise during wash and rinse cycle


The dishwasher make "loud high-pitched squealing sound" during the rinse cycle that is periodic through out the cycle

Nov 24, 2009 | Frigidaire Dishwashers

1 Answer

Washer squeals during wash & rinse cycles.


It sounds like you're brake stator & rotor is worn and merit replacement, it would also be prudent to replace the thrust bearing as well since you'll be in the same area for the repair. The way to verify is to place the unit in spin & allow it to reach speed then open the lid. If it squeals then the repair would need to performed, if it does not then further troubleshooting would be needed. Hope this helps... Bill

May 29, 2009 | Maytag PAV2300 Top Load Washer

1 Answer

Load squeal when it in the agitation cycle.


Most noises from a washing machine occur during the spin cycle. If you hear loud thumping during the spin, the load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it. Repeat these steps if necessary. 
for detailed help with diagrams and step by step instructions click the link http://www.applianceaid.com/washerspinnoise.html

Dec 29, 2008 | Admiral AW22 Top Load Washer

1 Answer

Dryer squeals off on during the cycle


The rear drum support must be replaced.
Part number 5303281153

Nov 29, 2008 | Frigidaire GLGH1642DS Front Load Stacked...

2 Answers

Loud squeal during wash and spin cycles, maytag atlantis washer


Squealing normal occurs due to belt slippage. I would check your belts (look for cracks. Check the belt tension as well, most washers have an adjustment, normally on the motor that allows you to increase the tension of the belt.

If part of a belt gets torn and it is long enough, it will hit any part of the washing machine within range and make a clicking noise at every revolution of the motor.

I am pretty sure you need new belts. You should be able to remove a few screws and open the back cover. Between the pulleys there is a tensioner...loosen that so you can remove the belt easily. replace it with a new belt and adjust the tension.

hope this helps

Feb 23, 2008 | Washing Machines

1 Answer

Squealing noise during spin cycle


The spin cycle activates the fast mode on the motor, squealing normal occurs due to belt slippage. I would check your belts (look for cracks. Check the belt tension as well, most washers have an adjustment, normally on the motor that allows you to increase the tension of the belt.

Jul 08, 2007 | Whirlpool LSB6200KQ Top Load Washer

Not finding what you are looking for?
Whirlpool LSQ7533JT Top Load Washer Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Brad Brown

Level 3 Expert

18166 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...