Question about Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher
The spinner arm itself may be blocked..............remove arm and check hold are clear..........
Posted on Jul 30, 2017
SOURCE: Pump won't stop draining
you will almost certainly have a build up of water in the base. remove the water and retry. check to see if limit switch is not sticking or has possibly gone faulty.failing this, your board is faulty.
Posted on Oct 08, 2007
SOURCE: Bosh dishwasher shu3322uc/22
check for leaks where the the top rack plugs into the rear. it might not be sealing. If your unit has the ability to change the top rack height check in the other position and see if it works. In my Samsung (Bosch in disguise) model The tube to the top rack plugs into one of two holes in the rear, depending which rack position I use. Something covers the hole not in use. Bosch uses two seperate pumps for washing and draining. So I don't think the pump could go partially bad. (This happens in other brands when the solenoid gets stuck between pump out and recirculate)
Posted on Jul 03, 2008
SOURCE: check water light is on
I had the same problem! First disconnect mains power, then switch off the mains water to the water input hose, and disconnect the hose. Disconnect the waste outlet hose from your drainage. ( this will release some water from the hose ends, so a washing up bowl would be handy ) You will need to tip the dishwasher on to it's back, be carefull not to damage the waste outlet hose, and watch out from more water spillage. Next remove the two screws on the base metal cover, and spring out the cover from the two side clips, the cover can then be removed, you should have a screw holding an earth lead remove screw and lead from cover.
Inside the bottom of the dishwasher you will see a small electric pump fitted to the side of the dishwashers drain, it has two wires with spade connector on them, disconnect these from the pump noting colour of the wires for reassembling. The pump has the same diameter hose as the outlet hose. Next carefully remove the rubber elbow pipe from the pump and hose end this will need to be washed with clean water. Then to remove the pump, press and hold down the locking tab, where the pump is fitted to the drain, and twist the pump anti-clockwise. The pump will then release from the drain. Inspect the pump impellers for damage, and that the pump has free movement, also check condition of the rubber O-ring. Inspect inside of drain for broken bits of china and glass, remove and clean, also check the outlet hose for any blockages.
( run some water though the hose backwards from the water tap and collect it in a bowl from the pump end of the hose ) Reassembly is the reverse of the above, check electrics inside have not got wet, if ok switch on. The check water light should now be off.
Posted on Jan 17, 2009
When a dishwasher acts like this, the most common problem is a blockage in the sump area, underneath the lower spray arm. Removing any/all filter and covers down there (screws will need to be removed) and inspecting with a flashlight, remove all debris (watch out for broken glass!) Also, inspect the "impeller" that is turned by the wash motor for damage or being loose while you are down there. Reassemble and test out.
If problems remain, the next most common problem is a failed wash motor. It is common over the years for it to weaken as it heads towards total failure. These motors, when they fail, can not be repaired, rather they must be replaced.
Please post back with what you find, OK?
Posted on Apr 14, 2009
Try twirling the spinner by hand to see if it is binding. If it looks ok then there could be something plugging the water passage to the spinner. If you have access to a water hose you could run water into that verticle passage pipe and see if there is an obstruction. If so it can be taken apart for cleaning.
Posted on May 13, 2009
Tips for a great answer:
Jul 03, 2014 | LG Dishwashers
May 24, 2014 | Bosch Dishwashers
Jun 20, 2013 | Washing Machines
May 17, 2011 | Dishwashers
Jan 22, 2010 | Dishwashers
Oct 15, 2009 | Frigidaire Dishwashers
May 03, 2009 | Dishwashers
Mar 14, 2009 | Dishwashers
Feb 06, 2008 | Dishwashers
Jul 06, 2020 | Galaxy Dishwashers
91 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: