THE CLIP IN ARM HAS BROKEN CAN I BUY ANOTHER ARM all it says on the arm is curitiba ah22 00 6050 and on the other arm made in austria

You can try to hook where the release used to attach with a seal pick, a dental mirror might also help you see the under side of the arm and guide you in hooking the right piece.

The arms on a dishwasher spin with water pressure remove your arm and thouroughly clean and flush through , also check for wear on the arm bushes to see if there is excessive wear , the washers may need to be changed. Check the supply hole to the top arm to make sure it is not blocked.

There is trick to putting the ice bale arm back on unless the water cup where the water comes into freezer has the round opening broken that holds the bale arm Click Here=> 628356 Water Fill Cup




Also the video clip from Parts Select will show you the way to do this way of reinstalling the bale arm. If movie does load below then click HERE Telling you how in words would not be as simple as the instructions given in the movie. Thumps up to Parts Select on that tutorial! I will be here if you have questions and please rate if helpful Thank You Sea Breeze

please check the wiper linkages.try to move the wiper arm if moving repair the wiper linkages or replace it

It useually clip in with a plastic clip, if that is broken use a cable tie for emergancy only and replace as soon as possable,if the clip did not break, boil water put in a cup, warm up the clip (still attached to the arm) and clip it back on and let it cool down naturally

THe wind doesn't just push the power arm off, it must be broken and will need be replaced, You need to check if the actuall bracket that holds the arm is broken as well. It has teeth on it which when the arm is put on it lock in place with a clip

Most likely it is the linkage between the driver and passenger blade arms. The easiest way to find out is to remove the cowling and look...you should see the wiper motor, the motor arm that links to the driver arm and the linkage between the driver arm and passenger arm...this is held together by a plastic clip and that clip is most likely going to be broken when you look...it's fairly easy to replace.

Either the second arm on the motor has come off. Or the arm splines are stripped out. The second arm connecting snap has probly come off or the clip may have broken. you can usually see the arms move inside the cowel just in front of the windshield through the holes

one mote. Look under the wiper arm cap at the end and see i f there is a nut. tighten it a bit if it is there. if no nut or bolt stud then the inside part of the wiper arm has stripped out.