Question about Coleman Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)

Pilot light wont stay on - Coleman Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)

1 Answer

Paul Carew

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.
Coleman Master
3,530 Answers

Clean flame sensor and it is in postion check connection if fitted , or check thermocouple , pilot could need cleaning ie too short ,

Posted on Dec 12, 2010

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1 Answer

Pilot on furnace wont stay lit

Sounds like the thermocouple is shot

Nov 09, 2014 | Dayton Gas Furnace Heater

1 Answer

Pilot light on Tempstar furnace wont stay lit. replaced thermo-couple and it still wont stay lit. what next???

Do you have a good pilot flame? Is it wrapping around the thermocouple good? You may need a new pilot orifice.

Mar 07, 2014 | Heating & Cooling

2 Answers

Oven wont lite

if its a pilot lightr that stays lit all the time,then its the thermocouple next to the pilot light thats bad and cant keep the pilot on

Nov 24, 2012 | Ovens

1 Answer

Pilot light wont stay lit, even when on high

Pilot lights are supposed to stay on when the flames are burning. If they didn't the flames would go out, because the pilot flame against the Thermocouple keeps the pilot burning. It's a safety feature.

Mar 08, 2011 | Heating & Cooling

1 Answer

M# 640HORT4 s# H07A090378---MY Pilot Light wont

need a new one.(pilot light)

May 14, 2010 | Water Heaters

1 Answer

My pilot light wont stay lit

Hi try cleaning the pilot light out make sure the thermo couple is in the flame,check where the tcouple goes in to the valve nothing stuck in there try this it could be the valve not working

Feb 07, 2010 | Heating & Cooling

3 Answers

Light pilot on Royal deep fryer. Pilot will not stay lit. Second fryer has larger pilot have no trouble keeping it lit. How can I adjust the pilot so that it will stay lit?

there is a small adjustment screw on the gas valve,turn it clockwise to increase pilot,if that does not work the vent cap on the gas regulator on the back of the unit could be stopped up,remove that cap ,clean out or replace unit can operate without it just fine.If you increase the pilot and it still wont stay lit replace the thermocouple

Feb 06, 2010 | Vulcan GR45 Deep Fryer

1 Answer

Pilot light wont stay on

yes there should be a screw to turn near gas control knob at front there is one for each burner and the oven

Aug 26, 2009 | Ovens

1 Answer

I don't know how to restart my old bosch water wizard 10p, pilot light has gone out.

get a long stick match, a flashlight remove lower inspection cover, find thermocouple and pilot light will be next to it,turn gas valve to pilot light and hold down,stick the match in by thermocouple till the pilot lights and hold valve down till pilot stays lit,this may take a minute or more,then release gas valve and see if pilot stays lit, if not retry,if it wont stay lit,the thermocouple is defective and needs replacement

Jul 12, 2009 | Bosch & Tankless LP Hot Water Heater