This is a toshiba error when running recovery discs on your machine. There are two reasons that this could occur, one would be corrupted Recovery Discs and the other is bad hardware (Hard Disk Drive).
While running a full system recovery from the Recovery Media,
the installation may fail -- and display one of the error messages listed below.
Possible causes of these error conditions are listed at right. Use this list as
a troubleshooting guide -- not as an absolute list of causes, as there may be
others.
"An error has occurred. ERROR :10-FC10-1710" -- may be
caused by a faulty hard drive.
"An error has occurred. ERROR :10-FC12-0241" -- may be
caused by a faulty hard drive or defective memory.
"An error has occurred. ERROR :10-FC12-045D" -- may be
caused by a faulty hard drive.
"An error has occurred. ERROR :10-FC06-0002" -- may be
caused by damaged recovery media or faulty hard drive.
"An error has occurred. ERROR :10-FC12-0970" -- may be
caused by defective memory.
In my case with this error:10-FC06-002, I found it to be the media . I used another Computer with image burn and reburnt the disks making sure there were no read or write errors in Imageburn.
This worked for me. I thought this because S.M.A.T never detected the HDD as bad.
Yo tengo el mismo problema, a mi sale el mismo error
HDD problem = Read Error.
10-fc06-oo2
7,952 views
Usually answered in minutes!
itoo have same proublum
I get this error using either the recovery discs or the recovery data on the hard drive partition.
Toshiba laptop, recovery cd gives me this error when restoring computer to factory conditions, exactly at 50%
An error has occurred
Error 10-fc12-045d
Recovery error.
×