How do u reset jvc camcorder - JVC GR-SXM240U Camcorder

If you're experiencing issues with the menu buttons on your JVC Everio GZ-MS120 camcorder after adjusting the settings, there are a few troubleshooting steps you can try:

1. Remove the power source: Disconnect the camcorder from any power source, including the battery and AC adapter. Leave it disconnected for a few minutes to ensure a complete power cycle.
2. Reset the camcorder: While the power source is disconnected, press and hold the "Reset" button on the camcorder. The reset button is usually located in a small hole or recessed area and may require a small pin or paperclip to access. Hold the button for several seconds, then release it.
3. Reconnect the power source: Reattach the battery or connect the AC adapter to the camcorder and turn it on. Check if the menu buttons are now responsive. If not, proceed to the next step.
4. Connect to a computer: Use the USB cable to connect your camcorder to a computer. Once connected, some camcorders allow you to control and adjust settings through the computer's software or firmware update utilities. Try accessing the settings through the computer interface to adjust the display brightness or perform a factory reset.
5. Contact JVC support: If the above steps don't resolve the issue, it's recommended to reach out to JVC's customer support for further assistance. They can provide specific guidance tailored to your camcorder model and help you troubleshoot the problem effectively.

Remember to provide as much detail as possible about the issue and the steps you've already taken when contacting support. This will help them provide accurate and efficient assistance.

Disconnect the battery pack or the DC power plug on the back of the camcorder if the LCD screen displays error code "01," "02" or "06." This resets the camcorder and unlocks the unit from safe mode. Wait 10 minutes before reconnecting power.

My JVC Camcorder Is Stuck in Safe Mode - eHow UK

How to Get a JVC Camcorder out of Safeguard Mode

https://itstillworks.com > jvc-camcorder-out-safeguard-...
These cameras contain sensors that can detect issues in their operation. When they detect an issue, they can put the camera into a special "Safeguard Mode" that ...

Maybe it's have not. Just take off battery .

Sounds like a software issue of your hd camcorder. Which apps do you have loaded? I would try a hard reset. Menu > Settings > SD card and Phone Storage > Factory Reset. If you still have the issue, get the phone swapped out.

Please check whether the Camcorder is fully charged. Then, try resetting the Camcorder to the factory settings. Try Power resetting the Camcorder.
To Power reset the Camcorder, remove the battery of the Camcorder press the ON button(if switch, then keep the switch in ON position) for 30 seconds and reinsert the battery in 1 minute. Then, check the operation of the Camcorder.
If the issue still persists, then service will be required. It seems to be an issue with the CCD of the Camcorder.

Have you tried contacting JVC for this issue? Have you also googled the problem for answer?

If you are hooking up via usb, then you will want to have the latest drivers downloaded. Then once drivers are downloaded and installed, then reset computer, turn on camcorder, then plug into usb, then run your media player or whatever program you are using to capture video from camcorder

WHEN U OPEN THE WIDE SCREEN U MAY SEE A RESET BUTTON, U MAY RESET AND TRY

Hi,

You can't reset the camcorder, i think you have an defective image sensor and must be replaced by an certifcated JVC center

The ccd block is starting to fail. Thats the chip thats the eye of the camcorder at the back of the lense assy. Its mounted on a small circuit board. You can find the chip at parts.com. Its just a matter of dissassembling the camcorder and removing the chip from the board and soldering another onto it taking care not to over heat the chip. You do need good soldering skills.

Tim