Need setting instructions for Nexxtech model 631 1461 upright weather trend alarm clock

I found an instruction manual for a C. Crane CC Pocket Radio that has a section on how to change the display/weather alert setting 1. Here are the steps to change the display setting:

Turn off the radio.
Press and hold the Display/Weather Alert button for 2 seconds.
The display will cycle through the following options: Time, Frequency, Alarm Time, Alarm Frequency, Weather Alert, and Off.
Release the button when the desired option is displayed.
If the above steps do not work, you can try resetting the radio to its factory defaults by following the instructions in the manual. Bear in mind, you likely would get a better answer if you supply brand and model of whatever you are asking about.

check your temperature sensor, maybe you need to change this?

The most common way to set those buttons is to tune in a station and then press and hold the button down that you want to set it to. It will beep of flash to show you that it has preset.

Contact Nexxtech on the web. Look for Support/Downloads/Manuals.

- Press the "Mode" button to enter Alarm mode
- Press the "Adjust" button to cycle through times zones
- Press the "Mode" button again once you've selected the correct time zone

See - http://downloads.thesource.ca/630/6302000/Manuals/manual.pdf

This is for Ultronic LCD clock/weather gadget.

keywords (from display)
Ultronic forecast week day humidity temperature trend comfort level
- DOWN = toggles F/C temp
- UP = toggles alarm
- MODE = selects date/time display
- hold down MODE to enter "set" mode for data currently displayed
- use momentary MODE to choose target item
- use UP/DOWN to change item

Often the trick is to hold one of the keys (time/mode?)
for about 3 seconds to go to the settings mode.

Hold the Timer button then press the Hour / Minute buttons to set the time.

I have the same clock and had the same problem. My clock was a demo and had no instructions with it. Here is the solution:
1. Pull out the battery and wait 10 seconds then replace the battery. The satellite symbol should start flashing after a few seconds.
2. Put the clock outside or in a window sill till it updates. This could take a couple of minutes.
3. Press the Mode button once to enter programming mode.
4. Press the Adjust button as many times as needed to toggle through the time zones.
5. Press the Mode button once to exit programming mode.

You did not supply a model number and the Nexxtech web site has no information, however, I did track down the supplier, Orbyx
Just enter the info model number etc. and see what comes up.
This is the maker of the Clock.
http://orbyxelectronics.com./manuals.asp?choice1=3&choice2=4&hidPickIndex=2