Loading
Insert a roll of labels into the gun opening so
that the beginning of the roll is at the back and comes up over the top
of the gun. Insert the beginning of the roll into the slot, squeezing
the trigger halfway. Push the labels through the gun until they come out
at the front. Thread the labels up and under the black plate on the
front of the gun and then under the rubber roller. Squeeze the trigger
again and pull six or seven labels out. Discard the labels, leaving the
paper backing. Thread the paper backing into the underside of the gun,
next to the handle, in the direction indicated by the arrow. Push the
paper backing while squeezing the trigger until the gun begins
dispensing labels.
Printing
To replace the ink
cartridge, turn the latch on the right side of the gun to an upright
position. Pull the door out. The ink roller is on the end of the door in
a plastic holder. Push the holder apart slightly to remove the old ink
roller and insert a new one. Replace the door and turn the latch to hold
it in place.
887 views
Usually answered in minutes!
×