SOURCE: About my On Board Video Card
You better off getting an AGP card as your onboard graphics cannot be altered from what i can see and in any case will not be good enough to play most games as the 3d and shader won't is needed
SOURCE: SATA II HDD instaling on ASUS P5LD2
Drivers will not affect whether the drive shows up in BIOS or not.
Your BIOS should have a setting under the 'Advanced' section for IDE and or SATA. Usually this needs to be set to 'Enhanced' mode or 'SATA plus PATA' Check your jumper settings-The drive should be set to 'Master' (if it even has jumpers).Check the power lead to make sure the drive spins up. Try different power lead and different SATA cable. If possible, try the drive in another machine to make sure it isn't 'Bad out of the Box'
If the drive does not show up in BIOS its a hardware issue or BIOS setting .
Once it shows up in BIOS - you'll be good to go.
SOURCE: Asus M2N-MX Motherboard 4gb Ram wont work
http://www.tomshardware.com/forum/247818-30-memory-problems
SOURCE: CMOS Settings is Wrong! USB Device over Current Status Detected!
Hi,
It would seem that you posted twice, pls see you other post.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.
SOURCE: ''CMOS Settings Wrong! USB DEVICE OVER CURRENT STATUS DETECTED
Have you checked all USB port sockets to see if any of them are broken? I mean inside the socket itself.
It is easy to break the small plastic black tongue in these (e.g. by bending down on a USB memory stick. Then when you put another USB plug into it, the 4 contacts can get bent and the +5V will short out with the case.
Check all USB sockets.
213 views
Usually answered in minutes!
×