I have a beko wm5100w washing machine and it keeps tripping the electricity

Most likely a control board failure open it up and look for burned connectors

Seimins washing machine iq300 model
Nr.WD12D523GB/02WD child lock activate

Beko WM5100W Washing machine wash/spin problem ...

? 3:59
https://www.youtube.com/watch?v=rih6H1cpu9Q
Jun 12, 2012 - Uploaded by ilona ilona
problem in washing cycle. fast spin for few seconds and cut off .... I have same machine, it starts up fills half way with water then stops :'.

Washing machine stops mid cycle - White Goods Help

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

if theres only 2 wires they go no set way

With the machine unplugged, try disconnecting the heater and then turn the machine back on. If it is still tripping the electrics reconnect the heater and disconnect the motor, then turn on again. Likely one of those is causing the fault

It could be carbon brushes or electronic fault.

Do you have ability to check carbon brushes?

Feel free to ask if you dont know how to do it.

hello sound like there could be somethink stuck the in the pump like a coin or metal also check the filter if it has 1 and check the drain hose. hope it helps

regards
shaun

It could be a faulty thermistor (showing high temperature)
or water sensor fault that is causing the pump to run.
Just try and unplug it for 3-4 hours, and see if it resets itself,
if not replace sensors, and if that does not work, replace the main board.
Here is the manual:
http://laundry.manualsonline.com/manuals/mfg/beko/wm5100_1.html?p=21

This is the actual reset/diagnostic mode
https://www.youtube.com/watch?v=8C4J3leArY0

https://www.how-to-repair.com/help/beko-wm5100w-wm5100s-test-mode-and-error-codes/

hi - mine's just done this too; press and hold the two buttons above the padlock symbol until the light goes out. voila! that cost me 35 quid to an engineer but it's free to you... cheers!
good luck

sorry to hear about the problem it will be your motor or module try online for recon both these parts are prone to go on bekos