Question about Hotpoint 24 in. FDW60 Free-standing Dishwasher
My dishwasher starts but after 30 seconds it stops and the fast and delicate lights flash and then starts to drain the water out. can you help
Your control panel is bad.My advice is use your warranty if you have it .If you don't ,toss this machine out,there should have been a re-call on this .You are one of many many that are having to deal with a problem that the manufacturer should be liable for. Dont't let GE (hotpoint) go not knowing that your D/W is broken ,look for a class action law suit to be in the making,which is not enough to correct the problems at hand .I don't advise repairing this unless there is a modified part to replace the defective one. Again I'm with you on this ,and sorry for all the consumers that are ripped off by manufacturers (in my eyes) . Please rate this !
Posted on Jun 23, 2008
Tips for a great answer:
Jun 12, 2017 | Samsung Dishwashers
Jan 04, 2016 | Dishwashers
Jan 24, 2014 | Hotpoint 24 in. FDW60 Free-standing...
Nov 23, 2013 | Dishwashers
START/RESET status indicator light flashing
You have pressed the indicator light flashing START/RESET pad while the START/RESET dishwasher is running. This will cancel the cycle. The light will stop flashing after the dishwasher drains (about 90 seconds).
• Press the pad once to start the dishwasher. Press the pad a second time when the dishwasher is running only if you wish to cancel the cycle.
Power to the dishwasher was turned off while a cycle was running and power has just been restored to the dishwasher. The blinking lights indicate that the dishwasher is draining the potential water inside.
• The light will stop flashing after the dishwasher drains. A new cycle will start automatically.
Nov 29, 2010 | General Electric GLD6966RSS Stainless...
Jun 06, 2008 | Hotpoint 24 in. FDW60 Free-standing...
465 people viewed this question
Usually answered in minutes!