How do i view split screen( 2 channels at once) with Sony Bravia kdl 32 ex?

SOURCE: Sony Bravia KDL-40v3000

NISK-TRY USING YOUR DIRECTTV MENU AND LOOK AT THE SCREEN FORMAT SETTINGS AND MAKE SURE YOU ARE AT 16X9 SETTING.JOETV

SOURCE: Sony BRAVIA KDL-40W4000

Hi there,

I've been looking into this myself as I've also recently purchased the KDL-40W4000. I was watching a murky old film and was getting a bit of sludgy ghosting but found that by reducing the contrast to 25, setting the backlight on low, colour on neutral and the brightness about 40-60 (and taking ALL advanced noise functions off), this reduced the ghosting considerably.

BUT, this is quite a cool and dark image. If you watch standard TV and films mainly, a variation of the Cinema setting is probably the best overall setting i.e.

backlight: min
contrast: 79
brightness: 50
colour: 53
colour temp: Warm 2 (although Warm 1 is less yellow and still fine)
sharpness: min
noise reduction: off
mpeg nr: off
contrast enhancer: off
colour space: standard

Ben, UK

SOURCE: Sony Bravia KDL-40W4500 turns off

This can indicate a problem with the high voltage circuits. Since this is a new set, it should still be under warranty. DO NOT open up the unit as that will void the warranty. Return the set or request warranty service. Note the 8 blinks when you request service as that should allow them to bring the correct replacement parts.

Keep us posted.
Dan

SOURCE: tv bravia kdl 40v3000 problem turning on

Hello,

Unfortunately, this is a failure of the balancer board for the backlight. The unfortunate part is that the balancer is not available by itself anymore, and the whole panel must be replaced, as Sony only has the balancers attached to new panels. You can contact Sony directly to ask for assistance, and it usually helps.

Hope this helps you...

SOURCE: sony bravia kdl 46s4100 no picture

it sounds like your back light might be going out. You might be able to fix this by installing a new backlight inverter board.