Pass code for VR3 (Roadmaster VRTB100 Bluetooth)

If you're referring to the 200bt portable speaker set, this isnt possible. Car stereos are only designed for input over bluetooth not output. Now if it really important to you, you can use a line level adapter to tap into the rear speakers of your vehicle, take that output and plug it into your speakers with an aux cord, or if you have an after market radio you can use RCA cables and a jack adapter to do the same. If you must bluetooth (eg. out of vehicle operation of speakers) buy a cheap bluetooth output adapter (shark makes one) use a small cigarette lighter inverter to power it, and then you can plug your aux jack into it and bluetooth to a speaker set outside of the car. If you use this in conjunction with the speakers car there will be a delay between those speakers and your bluetooth speakers.

Either install a yahtoo bluetooth mp3 receiver for the radio or a fm transmitter for the cigarette lighter socket

If it plugs into the cigarette lighter, there may be a fuse in the tip of the plug

You should have the adapter with the bluetooth. Check the voltage required for the bluetooth.it may be less than 12 volts

if you not sure , always err on the side of caution , fit a lowish rated fuse for this usage ( 25/30 amp), if it blows , gradually uprate , and carry spares,

Turn on the Bluetooth device that you would like to sync to by pressing and holding the multifunction button on the device until the blue light turns on.

2

Navigate on your Vr3 phone through the main menu to "Settings," "Bluetooth," "Handsfree" and "New Device."

3

Click on the name of your Bluetooth device and enter the default passcode for the device, which is "0000" for Motorola devices.

4

Click "Connect" and your Vr3 will be synced with the passkey to the Bluetooth device.

Good Luck

The cigarette lighter plug should also work for the phone charger as long as the phone charger uses the cigarette lighter style plug(long with two metal contacts on the sides and a button contact on the tip). Most standard car chargers will fit both cigarette and auxillary style plugs.

Go here http://safemanuals.com/user-guide-instructions-owner-manual/VR3/VRBT200V-_E

Easy, just insert the "cigarette lighter style" plug from the A/C charger into the "cigarette lighter style" socket on the top of the unit, and then insert the A/C adapter in to a wall socket. It can also be charged in your car with a cord that has double "cigarette lighter style" plugs at ether end, one inserted in the Vector and the other in your cigarette lighter.
Wait, one more - clamp the units cables properly on to your cars battery terminals, then start your car. periodicly checking for full charge.
Hope it helps... Good luck

Hey dude,
U dont need to search for the pass keycode. It is the key u put on. Put on the same code on bluetooth which u have put in ur mobile/PS3.
=================================================
Send me a feedback. And Rate me if my solution is helpful !
=================================================