The battery went dead a long time ago and i just bought some batteries and they are the right kind because they fit its the right number and my royal dm4070R and the royal glo comes on too but nothing comes on what should i do?

You will need to replace the battery pack

remove alarm reinstall after fitting. at least cut power supply and back up supply fit battery repair reinstall alarm.

switch off, leave it to charge overnight. try again the next morning.

Your problem is showing up under the Powerware 9305 (a very large UPS) but your comments are about the 3105. It sounds like your battery is dead. If your UPS is over 3-5 years old, that's most likely the case. The website address to view the user manual is www.eaton.com/3105 You can contact Eaton directly, too. Eaton bought Powerware about 6 years ago. Here's the contact info. Be sure to have your serial and model numbers ready from the rating label on your UPS.

Toll Free: 1 800 356 5737
E-mail: [email protected]

may just be a loose terminal. I had mine replaced and it took a few hours before it ran right again. something about the electronic modules take a little time to recharge.

sounds like you have got dead cells in your battery , they wont hold a charge , the loud click was probably the cells in the battery arking and killing the cells off ,id fit a new battery and all should be well.
hope this helps
kind regards
bert31000

You need to Check out the Alternator.

call kenwood you need the model and serial number and they may charge $25...

I am guessing heat can only come from discharging the battery in a non-intentional way. Short circuit or something internal.

Did you plug it into something besides the connector it came with?
An FM transmitter for the iPod killed mine.
Hard reset, wall charging, USB charge, iTunes restore, replaced the battery ... still dead.
Considering how hot it gets, (could be a fire hazard?) surprised Apple doesn't issue a notice or warning.

Caveat emptor, going back to Motorola.

You probably don't have the batteries fully charged up. Also you will need to change battery type from alkaline to metal hydride in the "wrench2"(the last icon on the menu) menu. You did get metal hydride rechargeable batteries??? If you got nickel-cadmium rechargeables that might also be your problem with your camera as they don't have enough power.