Im trying to get my tv controls onto my dish network remote. 32" pol 03211. or get my satellite controls onto my polaroid tv remote.

From Ario Support website, hope this helps!

Cable and Satellite content providers control the remote codes, and we apologize for any confusion during the remote programming. Please try the following codes 10019, 0178, 10178, 0030, 10030, 0835, 10835, or for Dish Network try 627, 659 or 505. For Fios TV (Verizon), try the code 3264. These codes may not work on some universal remotes.

Check the tab on the bottom of your remote, make sure it has the blue number 2 tab in it.


Daniel Busa
DISH Network Customer Service

It would be our please to help you with that. Here is a list of remote codes for addressing the DISH remote to an Insignia TV: 720, 000, 697, 834, 544, 538, 638. Press and hold the TV button until all mode button back lights come on, then release. Use the number buttons to enter the Insignia codes. Press the pound (#) button. If the code entered is valid for the remote, the mode light flashes three times. Also remember to put the remote back in satellite mode. Thank you for being a valued DISH Network customer!

Phillip Chang
DISH Network Customer Support Representative

Try these steps for progamming the remote, if this doesn't help there is a compatibility issue.

1. With the desired equipment on, press and hold the correct Mode button until all mode button backlights illuminate (about 3 seconds), then release.
2. For AUX mode Power Scan ONLY: press 0 for a TV, press 1 for a VCR/DVD, press 2 for any other device, then press *.
3. Press and release the Power button.
4. Press the Up button once a second while pointing the remote at the desired equipment. If the code for the equipment comes up, the equipment will power off.
5. Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.
6. To verify the code works try several different functions for that equipment.
   

Daniel Busa
DISH Network Customer Service

Hi, Mary with Dish Network Customer Service here. It sounds like when you try to change channels with your remote, it is changing the channels on your TV and not your Satellite Receiver. In the top left corner of the Dish Network remote is an SAT button. When you try to change channels on the Satellite receiver this button should be lighting up. If the TV button lights up, it means the remote is working the TV. Press and release the "SAT" button after you have the picture back on the TV and it should work normally. I hope this resolves your remote issue!

Unplug the satelite box and replug it back like about an hour later.By letting the box resetting and upgrading it softwares the remote should work again now.

try 0019 it worked for me

I have ask some help from our friends and they also have problems regarding this type of TV... But try this one

Quotes from friends:
1. "The universal remote that came with my Motorola HD cable box worked fine"
2. chat sessions
3. Chat session find jcut92

My quote:
Ask the vendor for a code, if they don't give you return the TV , it lacks technical support... Believe me or else face more problems in the days to come.

I'm sorry, there's lo luck... Fixya me instead...

For the Direct White remote it is 10178

1000,1001,1002,1003,1004
MAGNAVOX and 0000,0001,0002,0003,0004
0057 PHILIPS and 0005,0006,0007,0008,0009